The Sportster and Buell Motorcycle Forum - The XLFORUM®

The Sportster and Buell Motorcycle Forum - The XLFORUM® (http://xlforum.net/forums/index.php)
-   Buell Motorcycle Top End (http://xlforum.net/forums/forumdisplay.php?f=226)
-   -   Advice on what to do with a HOTROD Blast (http://xlforum.net/forums/showthread.php?t=1648335)

vegabond 19th June 2013 23:31

Advice on what to do with a HOTROD Blast
 
I bought a Hotrod blast that is Blown up(dropped a valve) but this is a hotrod blast i.e. no elec. start-bump start only, PVL race ignition, Flat slide carb. clutch is hydrailic from the right side. (a factory buell short tracker prototype) the head is trash, the cylinder is a Nikosil <?spelling?> but has got some goughes. Ordered a new XB head bare and going to send it to NRHS for there stage two port work, valves and springs. the cases are NOT bored for the 600 kit so i am limited to the 515. wanted to get it running as inexpensive as possible. What does everyone think about getting started where or do i just buy NRHS 515 cylinder and piston and go on. It does have 585 cams in it as well. Wish I knew to post a picture it is a very neat bike.

A 4 liter V8 eater 23rd October 2013 15:39

Quote:

Originally Posted by vegabond (Post 4471443)
I bought a Hotrod blast that is Blown up(dropped a valve) but this is a hotrod blast i.e. no elec. start-bump start only, PVL race ignition, Flat slide carb. clutch is hydrailic from the right side. (a factory buell short tracker prototype) the head is trash, the cylinder is a Nikosil <?spelling?> but has got some goughes. Ordered a new XB head bare and going to send it to NRHS for there stage two port work, valves and springs. the cases are NOT bored for the 600 kit so i am limited to the 515. wanted to get it running as inexpensive as possible. What does everyone think about getting started where or do i just buy NRHS 515 cylinder and piston and go on. It does have 585 cams in it as well. Wish I knew to post a picture it is a very neat bike.

Is it a frame bike? I'd love to see a picture. As for what to do with it, I suggest selling it to me for cheap :smoke.

Panshovevo 10th December 2017 00:35

I might suggest doing what Erik did with the last one he built...;)

But seriously, I’ve wondered if you could stuff a two cylinder motor in one.


All times are GMT +1. The time now is 01:52.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC