Air Filter Elements for Hammer or NRHS housings
 

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM

Bump it up bump !

What is the benefit to this?

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now