Thread: Ironhead head specs
View Single Post
  #5  
Old 6th June 2012
fdny37's Avatar
fdny37 fdny37 is offline
Senior Master Bike Builder
 
Join Date: May 2006
Location: Planet Earth
Posts: 2,167
Reputation: 10371
fdny37 is a glorious beacon of lightfdny37 is a glorious beacon of lightfdny37 is a glorious beacon of lightfdny37 is a glorious beacon of lightfdny37 is a glorious beacon of lightfdny37 is a glorious beacon of lightfdny37 is a glorious beacon of lightfdny37 is a glorious beacon of lightfdny37 is a glorious beacon of lightfdny37 is a glorious beacon of lightfdny37 is a glorious beacon of light
Default

If you're going to pay those prices go to Baisley and get hot rod head work for the same price. While you're there get some roller rockers too.
__________________
93 Cubic Inches..3.635 Bore x 4.50 Stroke...Baisley Roller Rockers...Dual Plug Heads Ported With XLR Valves...Chrome Moly Pushrods...Andrews AX Grind Cams .550 Lift...Venolia Pistons...Total Seal Gapless Rings...Balanced S&S Rods & Flywheels...Blitz Steel Barrels...Billet Oil Pump...K&N O2 Sensors...S&S Super E Carb...Crane Fireball Multi Spark Ignition...All Andrews Trans Gears & Shafts...Strociek Billet Trap Door...Barnett Kevlar Wet/Dry Clutch...Motorsport Rear Motor Mount...High Torque Starter...100 Plus HP
Reply With Quote