The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > FORUM FUNCTIONS > Introduce Yourself
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Introduce Yourself Tell us about yourself and your bike

Active Threads
0 Introduction
Last Post: 93sportsXLH
Posted On: 2 Minutes Ago
Replies: 13
Views: 175
0 Hello From Cayman Islands
Last Post: juzyHD
Posted On: 3 Minutes Ago
Replies: 5
Views: 14
5 Summer time heat
Last Post: doodah man
Posted On: 4 Minutes Ago
Replies: 5
Views: 46
0 What brand synthetic oil do you use
Last Post: 60Gunner
Posted On: 4 Minutes Ago
Replies: 394
Views: 100,849
0 Vote for your favorite Babe Jump Babe.....
Last Post: Crusty
Posted On: 25 Minutes Ago
Replies: 19
Views: 1,760
0 Replacing Stock Sealed Beam Headlight in my 1991
Last Post: IXL2Relax
Posted On: 42 Minutes Ago
Replies: 13
Views: 205
0 Mid or forward controls.
Last Post: Beelzeboss
Posted On: 52 Minutes Ago
Replies: 144
Views: 38,473
0 Air Filter Soaks With Gas
Last Post: John Harper
Posted On: 56 Minutes Ago
Replies: 14
Views: 171
0 LED turn signals problem?
Last Post: IXL2Relax
Posted On: 59 Minutes Ago
Replies: 10
Views: 127
0 1986-90 Evo Sportsters: What every owner should know but were afraid to ask
Last Post: lehel
Posted On: 1 Hour Ago
Replies: 259
Views: 30,886
0 1981 ironhead xlh PROJECT
Last Post: owlsplace
Posted On: 1 Hour Ago
Replies: 2
Views: 151
0 Was your 1st bike a Sportster?
Last Post: 2cvandy
Posted On: 1 Hour Ago
Replies: 979
Views: 220,274
0 Forks and Triple Tree and wheels?
Last Post: CaymanHarley
Posted On: 1 Hour Ago
Replies: 0
Views: 10
0 VOES Switch on CV carb conversion.
Last Post: IXL2Relax
Posted On: 1 Hour Ago
Replies: 16
Views: 418
0 compression problems
Last Post: GA_Ironhead
Posted On: 1 Hour Ago
Replies: 73
Views: 3,388
0 Crusty's Travels
Last Post: BKB
Posted On: 1 Hour Ago
Replies: 2,010
Views: 241,388
0 A Day in the Life...
Last Post: DK Custom
Posted On: 1 Hour Ago
Replies: 625
Views: 67,851
0 900 dual carb front head
Last Post: brucstoudt
Posted On: 1 Hour Ago
Replies: 13
Views: 524
0 Hottie of the day, no nudity.
Last Post: Stairman
Posted On: 1 Hour Ago
Replies: 10,315
Views: 906,561
0 ParrotHead's 2019 Winter/Spring maintenance
Last Post: ChinCactus
Posted On: 1 Hour Ago
Replies: 51
Views: 13,341
0 Clutch won't disengage
Last Post: sgr60
Posted On: 1 Hour Ago
Replies: 3
Views: 196
0 A different Oil filter test
Last Post: shanneba
Posted On: 2 Hours Ago
Replies: 4
Views: 158
0 sporty
Last Post: harley506d
Posted On: 2 Hours Ago
Replies: 3
Views: 41
0 Tacho Ratio's
Last Post: Ferrous Head
Posted On: 2 Hours Ago
Replies: 9
Views: 319
0 Roads I'd like to ride.
Last Post: Stairman
Posted On: 2 Hours Ago
Replies: 1,415
Views: 123,111
0 This week on Craig's list
Last Post: Ferrous Head
Posted On: 2 Hours Ago
Replies: 3,827
Views: 432,144
0 Gotta Start a Thread for the Streetfighter Too!
Last Post: Nibelungen
Posted On: 2 Hours Ago
Replies: 96
Views: 17,928
0 Peanut, 3.3 or 4.5 gas tank ?
Last Post: 83XLX
Posted On: 2 Hours Ago
Replies: 222
Views: 61,718
0 1980 Sputhe Sportster
Last Post: Ferrous Head
Posted On: 2 Hours Ago
Replies: 53
Views: 2,814
0 Supertrapp exhaust too &%$#in loud!
Last Post: themadone
Posted On: 2 Hours Ago
Replies: 41
Views: 2,197
More...
Members Birthdays
drifter44 (75), Streak70 (71), Rayzer (61), ridefree1 (57), erk (53), LOBO (51), motley79 (40), polaris0352 (38), TManos916 (38)
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #11  
Old 11th October 2018
Scuba10jdl's Avatar
Scuba10jdl Scuba10jdl is offline
XL FORUM TEAM MEMBER
 
Join Date: Dec 2010
Location: Columbus, Ohio
Posts: 1,324
Sportster/Buell Model: XLH883/1250
Sportster/Buell Year: 2002
Sportster/Buell Model #2: XLCH 1000
Sportster/Buell Year #2: 1972
Reputation: 394858
Scuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond repute
Default

Welcome my friend! Starting an ironhead, especially a kick only CH, can be a challenge if you've never done it before. Here's the sequence I use for mine ( carb S&S Super E with acclerator pump):

- Ignition off
- Full choke
- Twist throttle once (accelerator pump squirts)
- Kick through one cylinder
- Twist throttle again
- Kick through second cylinder
- Bring crank to compression and ready to kick
- Ignition on
- Kick like hell

At this point it should start right up. If it pops out the carb, it's lean and you didn't prime it enough or you kicked too slow. If it backfires, your timing is probably off.

If it doesn't start the first try and didn't pop out the carb or backfire (a little hiccup is okay), then kick it again.

If it fails to start on the second kick, turn off the ignition, close choke, open the throttle all the way and kick through three or four times. Then start back at the top.


The first time I tried to start mine I had my buddies out there watching me, we were all drinking some beers, and it was hot as hell Ohio summer. I spent about 45 minutes kicking and kicking, and doing everything every which way. After much ridicule, and my buddies getting shamed failing to start it as well, we put it away and I came back to it the next day. Read a similar procedure to above and tried that. Over time I've perfected it for my bike. Each one is different, so don't think you have to do it exactly how I do as it may not even work for your bike that way! (But it should get you pretty close.)
__________________

2002 XLH883/HAMMER1250 - 1972 XLCH 1000 - Few things in life are as satisfying as riding a Sportster with no destination in mind.
Reply With Quote
  #12  
Old 15th October 2018
hoggy's Avatar
hoggy hoggy is offline
XL FORUM TEAM MEMBER
 
Join Date: Aug 2009
Posts: 319
Sportster/Buell Model: xl 1200
Sportster/Buell Year: 1994
Sportster/Buell Model #2: xl883/1200conversion
Sportster/Buell Year #2: 1995
Reputation: 3665
hoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the rough
Default

welcome & enjoy.
Reply With Quote
  #13  
Old 15th October 2018
juzyHD's Avatar
juzyHD juzyHD is online now
Senior Chief Harley Engineer 2nd Class
 
Join Date: Mar 2015
Location: Europe Slovenia
Posts: 1,604
Sportster/Buell Model: sportster 1200
Sportster/Buell Year: 1986
Reputation: 559247
juzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond repute
Default

Welcome from Slovenia!
Reply With Quote
  #14  
Old 16th October 2018
echale3 echale3 is offline
XL FORUM TEAM MEMBER
 
Join Date: Sep 2018
Posts: 10
Sportster/Buell Model: XLCH 900
Sportster/Buell Year: 1971
Sportster/Buell Model #2: XL883C
Sportster/Buell Year #2: 2007
Reputation: 10
echale3 is an unknown quantity at this point
Default Well....

The carb is a Bendix, not the Tillotson, and when I got it, the bike wasn't running. Turns out the rear pushrods were WAY out of whack to where the intake/exhaust in the rear weren't even opening and closing, the points were gapped wrong, the static timing was unable to be set because of wear on part of the points that rides on the timing cam, and the carb had a leak. Took care of all of that, and put in a fresh battery, and it still won't go, so I'm going to tweak the carb settings a bit and see if that helps.


I'll be quizzing the Ironhead forum guys shortly, and thanks for all the advice and welcomes!
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 23:44.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC