The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 How to remove internal throttle cable
Last Post: The Doctor71
Posted On: 1 Minute Ago
Replies: 2
Views: 43
0 Carb issues
Last Post: 60Gunner
Posted On: 9 Minutes Ago
Replies: 6
Views: 108
0 Peanut, 3.3 or 4.5 gas tank ?
Last Post: Diogenes415
Posted On: 10 Minutes Ago
Replies: 217
Views: 55,851
0 Fact or Fiction - HP Claims
Last Post: jcro61
Posted On: 14 Minutes Ago
Replies: 739
Views: 85,420
4 Cross Country Prep
Last Post: 1Scooter
Posted On: 15 Minutes Ago
Replies: 9
Views: 204
0 How many miles do you have on your rubbermount?
Last Post: sportsterpaul
Posted On: 24 Minutes Ago
Replies: 381
Views: 69,934
0 What brand synthetic oil do you use
Last Post: Ridneck1986
Posted On: 28 Minutes Ago
Replies: 377
Views: 92,278
0 2018 East Coast Meet & Greet
Last Post: cotton1
Posted On: 45 Minutes Ago
Replies: 621
Views: 34,649
0 How dangerous is 2k clear coat really?
Last Post: 60Gunner
Posted On: 46 Minutes Ago
Replies: 17
Views: 493
0 Right Angle Plug Caps and Leads
Last Post: rocketmangb
Posted On: 49 Minutes Ago
Replies: 1
Views: 30
0 Best Riding/Motorcycle Memes-Let's see 'em!
Last Post: Lone Rider
Posted On: 1 Hour Ago
Replies: 175
Views: 24,176
0 Hottie of the day, no nudity.
Last Post: trainman
Posted On: 1 Hour Ago
Replies: 7,116
Views: 508,027
0 Intake manifold gasket fitment
Last Post: BlackBettyXLC
Posted On: 1 Hour Ago
Replies: 12
Views: 166
0 What kind of saddle do you use on your sporty?
Last Post: Ridneck1986
Posted On: 1 Hour Ago
Replies: 263
Views: 63,622
0 End of the road for me
Last Post: jcn59
Posted On: 2 Hours Ago
Replies: 18
Views: 602
0 Sportsterpedia Progress
Last Post: jammantoo
Posted On: 2 Hours Ago
Replies: 161
Views: 31,514
0 1962 XLCH Front Wheel WTB
Last Post: Jaykel
Posted On: 2 Hours Ago
Replies: 0
Views: 24
0 Poll: Hwy Pegs: fwd mount or crash bar mount?
Last Post: jammantoo
Posted On: 2 Hours Ago
Replies: 62
Views: 22,237
0 Hot Chicks on Hot Bikes
Last Post: lugster
Posted On: 2 Hours Ago
Replies: 8,980
Views: 1,275,474
0 2 wire turn signal installing on 1 wire bike
Last Post: chris16371
Posted On: 2 Hours Ago
Replies: 0
Views: 25
0 Lost compression?
Last Post: Dave L
Posted On: 2 Hours Ago
Replies: 37
Views: 1,094
0 Sudden stiff rear brake pedal.
Last Post: rocketmangb
Posted On: 2 Hours Ago
Replies: 4
Views: 125
0 New Hammer Impact Air Intake Powder Coated
Last Post: rocketmangb
Posted On: 3 Hours Ago
Replies: 1
Views: 88
0 33.4 fork axle help
Last Post: Bturkey
Posted On: 3 Hours Ago
Replies: 10
Views: 191
0 TC88A and Raptor shift light
Last Post: rocketmangb
Posted On: 3 Hours Ago
Replies: 6
Views: 166
0 Hillbilly Hot Dogs
Last Post: gravydog
Posted On: 3 Hours Ago
Replies: 21
Views: 496
0 Stuck in fist after a spill
Last Post: Glamazon
Posted On: 3 Hours Ago
Replies: 1
Views: 54
0 Pictures of Sportster Scene 1960s
Last Post: BSA Bob
Posted On: 4 Hours Ago
Replies: 1,816
Views: 778,046
More...
Members Birthdays
stevervp, philvet (75), outlawreb (63), rabes56 (62), Bigmatt (60), Beaker666 (54), hippiemwc (54), wumm883c (52), 2wheeltodd (51), israel (46), XRWeasel (44), Stitch (41), Dekooy (35), Titaniumrust (35), Ameri-Deutsch (34)
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is online now
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,348
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2612129
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is online now
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,348
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2612129
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,580
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1076922
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)



Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch with Energy One 15% heavier spring plate, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from a 2012 street glide with matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is online now
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,348
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2612129
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 03:10.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC