The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 Dirt bike front wheel??
Last Post: 45Brit
Posted On: 1 Minute Ago
Replies: 15
Views: 825
0 I guess it''s true. (2019 The Last Year For The Sportster?)
Last Post: Nibelungen
Posted On: 13 Minutes Ago
Replies: 120
Views: 5,051
0 trans slips in 2nd gear 1989 883
Last Post: juzyHD
Posted On: 35 Minutes Ago
Replies: 4
Views: 91
0 Start up
Last Post: ryder rick
Posted On: 1 Hour Ago
Replies: 9
Views: 197
0 This week on Craig's list
Last Post: ryder rick
Posted On: 1 Hour Ago
Replies: 4,234
Views: 492,115
0 What brand synthetic oil do you use
Last Post: Bikeaholic
Posted On: 2 Hours Ago
Replies: 436
Views: 107,719
0 Buell heads and cams!
Last Post: aswracing
Posted On: 2 Hours Ago
Replies: 2
Views: 57
0 Bike can't go over 75miles.
Last Post: hammer6315
Posted On: 2 Hours Ago
Replies: 13
Views: 714
0 What oil and filter to use in 2005 1200c
Last Post: hammer6315
Posted On: 2 Hours Ago
Replies: 39
Views: 1,037
0 You asked for it! "The Tess' Coffee Thread"
Last Post: sportsterpaul
Posted On: 3 Hours Ago
Replies: 10,853
Views: 887,807
0 gearing is too high ?
Last Post: rocketmangb
Posted On: 3 Hours Ago
Replies: 65
Views: 3,577
0 Need some advice on 1983 Ironhead
Last Post: IronMick
Posted On: 3 Hours Ago
Replies: 4
Views: 113
0 First startup
Last Post: Iron Mike
Posted On: 3 Hours Ago
Replies: 10
Views: 372
0 Problem with my 1998 1200S
Last Post: ftwflh
Posted On: 4 Hours Ago
Replies: 3
Views: 127
0 Torx screws on clutch cover
Last Post: wedge
Posted On: 5 Hours Ago
Replies: 5
Views: 133
0 Show your favorite pic of your bike. just one
Last Post: Lone Rider
Posted On: 5 Hours Ago
Replies: 4,729
Views: 1,805,387
0 Harley Restoration Book
Last Post: John Harper
Posted On: 7 Hours Ago
Replies: 2
Views: 89
0 Share your Sunrise OR Sunset Photos!
Last Post: DK Custom
Posted On: 7 Hours Ago
Replies: 21
Views: 1,037
0 Hottie of the day, no nudity.
Last Post: trainman
Posted On: 8 Hours Ago
Replies: 13,074
Views: 1,197,565
0 Power Loss At Sustained High RPMs
Last Post: rocketnorton
Posted On: 9 Hours Ago
Replies: 27
Views: 874
0 Who Runs Turn Signals?
Last Post: lespaul6
Posted On: 9 Hours Ago
Replies: 351
Views: 72,805
0 Grenade Plate
Last Post: rocketmangb
Posted On: 9 Hours Ago
Replies: 17
Views: 511
0 Tachos, heads, drives abd Cables
Last Post: Scootin-Newton
Posted On: 9 Hours Ago
Replies: 19
Views: 1,129
0 Call the new 2020 models Sportsters?
Last Post: jzink0883
Posted On: 9 Hours Ago
Replies: 140
Views: 12,490
0 Official XL Forum Random Image Thread (NO NUDITY!)
Last Post: Graywolf
Posted On: 9 Hours Ago
Replies: 44,715
Views: 7,030,713
0 Rocker Lockers - Quiet Down Annoying Top End Ticking
Last Post: DK Custom
Posted On: 10 Hours Ago
Replies: 69
Views: 20,305
0 Sadly Leaving
Last Post: jcn59
Posted On: 10 Hours Ago
Replies: 18
Views: 672
0 Bigger valves
Last Post: 60Gunner
Posted On: 10 Hours Ago
Replies: 5
Views: 182
0 DK Coil and Coil/Key Relocation Customer Review and Pics
Last Post: DK Custom
Posted On: 10 Hours Ago
Replies: 85
Views: 22,088
0 New Here, building drag bike with Buell M2
Last Post: aswracing
Posted On: 12 Hours Ago
Replies: 2
Views: 119
More...
Members Birthdays
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is online now
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,072
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 3656817
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is online now
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,072
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 3656817
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,789
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1426028
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)



Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch, Energy One 15% heavier spring, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from 2012 street glide w/ matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

Dyno Sheet
96.21 HP/88.70 TQ


States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is online now
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,072
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 3656817
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 06:49.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC