The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 XR-Cafe-Conversion
Last Post: Screw Loose Dan
Posted On: 1 Minute Ago
Replies: 281
Views: 49,937
0 Screw Loose's Repairs
Last Post: Screw Loose Dan
Posted On: 18 Minutes Ago
Replies: 307
Views: 44,377
0 Whats a bigger priority - FF or W/shield?
Last Post: 60Gunner
Posted On: 19 Minutes Ago
Replies: 91
Views: 11,738
0 Best Tires to get 2017
Last Post: cotton1
Posted On: 20 Minutes Ago
Replies: 115
Views: 16,632
0 Lost compression?
Last Post: Darkseacret
Posted On: 21 Minutes Ago
Replies: 42
Views: 1,266
0 How many miles do you have on your rubbermount?
Last Post: ParrotHead
Posted On: 26 Minutes Ago
Replies: 382
Views: 69,958
0 **DK Custom- *NEW* Sportster Slip Stream Skid Plate-10% Introductory Savings**
Last Post: DK Custom
Posted On: 35 Minutes Ago
Replies: 5
Views: 201
0 ....1
Last Post: bplinson
Posted On: 38 Minutes Ago
Replies: 4,525
Views: 209,821
0 Bob from Appleton WI
Last Post: shanneba
Posted On: 39 Minutes Ago
Replies: 5
Views: 62
0 1990 Sportster. Something is pulling voltage from battery??
Last Post: IXL2Relax
Posted On: 49 Minutes Ago
Replies: 2
Views: 50
0 Primary fluid escapeing into crancase
Last Post: juzyHD
Posted On: 50 Minutes Ago
Replies: 11
Views: 186
0 Was your 1st bike a Sportster?
Last Post: khav
Posted On: 55 Minutes Ago
Replies: 972
Views: 210,395
0 As far as maintenance goes...Cycle Electric or Alternator?
Last Post: ericfreeman
Posted On: 1 Hour Ago
Replies: 3
Views: 104
0 How dangerous is 2k clear coat really?
Last Post: Hippysmack
Posted On: 1 Hour Ago
Replies: 22
Views: 660
0 Hot Rods, Rat Rods, and Customs.
Last Post: lugster
Posted On: 1 Hour Ago
Replies: 2,513
Views: 192,613
0 check my chain?
Last Post: Fridge
Posted On: 1 Hour Ago
Replies: 8
Views: 251
0 Shop Arson
Last Post: ss396
Posted On: 1 Hour Ago
Replies: 4
Views: 313
0 Do you have the service manual?
Last Post: bimbo
Posted On: 1 Hour Ago
Replies: 704
Views: 174,177
0 Roads I'd like to ride.
Last Post: Stairman
Posted On: 2 Hours Ago
Replies: 123
Views: 5,029
3 Restored, original or near-stock Ironhead pictures
Last Post: khav
Posted On: 2 Hours Ago
Replies: 766
Views: 374,931
0 Oil Pump upgrade
Last Post: hotrodbiker
Posted On: 2 Hours Ago
Replies: 10
Views: 254
0 one sporty and $5000... What would you do?
Last Post: jordan1200
Posted On: 2 Hours Ago
Replies: 274
Views: 126,746
0 What did you do for your sporty Today?
Last Post: Crusty
Posted On: 2 Hours Ago
Replies: 5,213
Views: 566,393
0 My take on the world ~ Photo by Trace
Last Post: Nibelungen
Posted On: 2 Hours Ago
Replies: 764
Views: 80,802
0 How many Sporty seats ya got for one ass?
Last Post: VaFish
Posted On: 3 Hours Ago
Replies: 258
Views: 50,741
0 New Hammer Impact Air Intake Powder Coated
Last Post: Outtakes
Posted On: 3 Hours Ago
Replies: 4
Views: 163
0 first change, very little oil
Last Post: rocketmangb
Posted On: 3 Hours Ago
Replies: 2
Views: 52
0 Who Runs Turn Signals?
Last Post: vagrant318
Posted On: 3 Hours Ago
Replies: 341
Views: 66,984
0 Free to a Good Home (pay $8 shipping only):2014 FSM, used
Last Post: rocketmangb
Posted On: 3 Hours Ago
Replies: 6
Views: 355
0 Removing powder coat?
Last Post: Oli1200
Posted On: 3 Hours Ago
Replies: 10
Views: 359
More...
Members Birthdays
stevervp, philvet (75), outlawreb (63), rabes56 (62), Bigmatt (60), Beaker666 (54), hippiemwc (54), wumm883c (52), 2wheeltodd (51), israel (46), XRWeasel (44), Stitch (41), Dekooy (35), Titaniumrust (35), Ameri-Deutsch (34)
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,353
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2612129
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,353
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2612129
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,580
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1076922
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)



Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch with Energy One 15% heavier spring plate, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from a 2012 street glide with matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,353
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2612129
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 18:37.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC