The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 CV Carb hesitation
Last Post: Billy1200
Posted On: 6 Minutes Ago
Replies: 2
Views: 186
0 Rear mount for solo seat?
Last Post: IXL2Relax
Posted On: 30 Minutes Ago
Replies: 1
Views: 69
8 New build - engine ping / gnarly vibration
Last Post: ironheed
Posted On: 42 Minutes Ago
Replies: 4
Views: 82
0 Lengthen 49mm forks, Sportster 48 ?
Last Post: XL Dane
Posted On: 46 Minutes Ago
Replies: 0
Views: 5
0 Adaptive headlight issues
Last Post: IXL2Relax
Posted On: 1 Hour Ago
Replies: 14
Views: 260
0 Have i knackered something ?
Last Post: Billy1200
Posted On: 1 Hour Ago
Replies: 4
Views: 222
0 What Sort Of Sporty Have You Got?
Last Post: rokytnji
Posted On: 2 Hours Ago
Replies: 1,140
Views: 338,791
0 Transformer XR1200
Last Post: Davo_137
Posted On: 3 Hours Ago
Replies: 429
Views: 47,063
0 First Harley ...
Last Post: juzyHD
Posted On: 3 Hours Ago
Replies: 11
Views: 174
0 Keep & Kill
Last Post: hammer6315
Posted On: 3 Hours Ago
Replies: 17,809
Views: 1,040,936
0 Magneto insulating block removal
Last Post: Captain Johnny
Posted On: 3 Hours Ago
Replies: 7
Views: 317
0 Poll: Do you change tires yourself?
Last Post: Bluto
Posted On: 4 Hours Ago
Replies: 135
Views: 35,976
0 'Floppy' Forks ???
Last Post: Iron Mike
Posted On: 5 Hours Ago
Replies: 7
Views: 115
0 Bendix insulator block
Last Post: Hippysmack
Posted On: 5 Hours Ago
Replies: 11
Views: 249
0 Hot Chicks on Hot Bikes
Last Post: trainman
Posted On: 5 Hours Ago
Replies: 10,875
Views: 2,101,201
0 Hottie of the day, no nudity.
Last Post: trainman
Posted On: 5 Hours Ago
Replies: 20,699
Views: 2,126,452
0 '69 XLH wiring question
Last Post: sleighcrane
Posted On: 5 Hours Ago
Replies: 8
Views: 147
0 Hagerty Insurance
Last Post: Maxeffort
Posted On: 5 Hours Ago
Replies: 1
Views: 91
0 Breather timing off just a bit 1974 engine
Last Post: kitabel
Posted On: 6 Hours Ago
Replies: 6
Views: 310
0 Thread revival
Last Post: ferretface
Posted On: 7 Hours Ago
Replies: 5
Views: 126
0 What did you do for your sporty Today?
Last Post: ChinCactus
Posted On: 7 Hours Ago
Replies: 7,061
Views: 1,005,070
0 After years of Japanese bikes I got a sportster..
Last Post: Michman
Posted On: 7 Hours Ago
Replies: 23
Views: 558
0 Memphis Shades Fats Drop-Top Windshield
Last Post: Folkie
Posted On: 8 Hours Ago
Replies: 1
Views: 41
0 77 XLT smokes a lot on start up
Last Post: Kingrabbit
Posted On: 8 Hours Ago
Replies: 2
Views: 261
0 Removing oil tank DIY?
Last Post: oldboy
Posted On: 8 Hours Ago
Replies: 6
Views: 180
0 Paint Code for 1976 Sportster
Last Post: Parker 1000
Posted On: 8 Hours Ago
Replies: 7
Views: 234
0 Official XL Forum Random Image Thread (NO NUDITY!)
Last Post: Graywolf
Posted On: 9 Hours Ago
Replies: 47,966
Views: 7,704,688
0 Hot Rods, Rat Rods, and Customs.
Last Post: Stairman
Posted On: 10 Hours Ago
Replies: 4,149
Views: 594,794
0 86 c I burning pistons
Last Post: kitabel
Posted On: 11 Hours Ago
Replies: 10
Views: 972
0 Scrambler muffler for 1960’s XLHC
Last Post: brucstoudt
Posted On: 12 Hours Ago
Replies: 25
Views: 3,014
More...
Members Birthdays
reinhard (65), randolph196 (64), dexter (63), Swamp Fox (63), drewsport (58), paintslinger16 (57), grumpy0868 (52), Prototype (40), Tustan (40), dustom_99 (37)
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,906
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4400645
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch (now with Barnett Pressure plate and 25% stiffer spring)
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,906
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4400645
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,940
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1723729
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)


Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch, Energy One 15% heavier spring, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from 2012 street glide w/ matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

Dyno Sheet
96.21 HP/88.70 TQ


States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,906
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4400645
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT +1. The time now is 09:30.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC