The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE FORUM > Sportster Motorcycle General Discussion and Problems
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Sportster Motorcycle General Discussion and Problems For discussing problems about your Sportster motorcycle that don't fit anywhere else.

Active Threads
0 Hardtail sporty ideas
Last Post: THEWILDONE
Posted On: 1 Hour Ago
Replies: 10
Views: 606
0 Eating Battery
Last Post: Akdawg
Posted On: 1 Hour Ago
Replies: 4
Views: 198
0 WTF is it with these F'n rocker cover leaks!
Last Post: Hippysmack
Posted On: 1 Hour Ago
Replies: 104
Views: 1,731
0 Another afflicted SE A/C setup
Last Post: rejeanprimeau
Posted On: 2 Hours Ago
Replies: 410
Views: 87,097
0 Iree's late night cafe
Last Post: rokytnji
Posted On: 2 Hours Ago
Replies: 1,258
Views: 155,718
0 how many run baffles, run open, or just run stock
Last Post: a-sad-anorak
Posted On: 2 Hours Ago
Replies: 411
Views: 93,651
0 Riding in The Heat!
Last Post: rokytnji
Posted On: 2 Hours Ago
Replies: 38
Views: 1,655
0 Brake Line Part Number ?
Last Post: Old Junk
Posted On: 3 Hours Ago
Replies: 7
Views: 279
0 1975 xlch1000
Last Post: doodah man
Posted On: 4 Hours Ago
Replies: 11
Views: 552
0 How many Sporty seats ya got for one ass?
Last Post: tigger
Posted On: 4 Hours Ago
Replies: 261
Views: 54,598
0 Can you Drown a Sportster ???
Last Post: broknluck
Posted On: 4 Hours Ago
Replies: 24
Views: 711
0 Grounded
Last Post: Nibelungen
Posted On: 4 Hours Ago
Replies: 67
Views: 2,726
0 I guess I'm back
Last Post: joes95bobber
Posted On: 4 Hours Ago
Replies: 37
Views: 1,016
0 Cold Start. Then stall
Last Post: Toejam503
Posted On: 5 Hours Ago
Replies: 3
Views: 142
7 Oldest Motorcycle You've Owned
Last Post: Crusty
Posted On: 5 Hours Ago
Replies: 61
Views: 3,032
0 What kind of saddle do you use on your sporty?
Last Post: SLW210
Posted On: 5 Hours Ago
Replies: 282
Views: 76,674
0 2020 Sportster?
Last Post: Kbetts
Posted On: 6 Hours Ago
Replies: 36
Views: 1,396
0 Parrothead and the 2019 Iron Butt Rally
Last Post: Cindy Dietz
Posted On: 6 Hours Ago
Replies: 105
Views: 5,631
0 The one and Only O-Fish-shall Poser thread.
Last Post: Graywolf
Posted On: 6 Hours Ago
Replies: 332
Views: 171,589
0 looking to swap mids for forwards
Last Post: IXL2Relax
Posted On: 7 Hours Ago
Replies: 3
Views: 187
0 Hottie of the day, no nudity.
Last Post: Stairman
Posted On: 7 Hours Ago
Replies: 12,206
Views: 1,114,650
0 2003 XLH1200 - Tachometer died
Last Post: IXL2Relax
Posted On: 7 Hours Ago
Replies: 2
Views: 116
0 75 XLH Bendix Carb Spitting Gas - Video
Last Post: Kennyv
Posted On: 8 Hours Ago
Replies: 16
Views: 625
0 The Rabbi
Last Post: trainman
Posted On: 8 Hours Ago
Replies: 2
Views: 1,148
0 Crusty's Travels
Last Post: ChinCactus
Posted On: 9 Hours Ago
Replies: 2,281
Views: 286,421
0 Clutchlite ramps with pictures
Last Post: jkinkade
Posted On: 9 Hours Ago
Replies: 29
Views: 4,908
0 Alternator/generator Conversion
Last Post: wymanv
Posted On: 10 Hours Ago
Replies: 135
Views: 68,485
5 Your worst car?
Last Post: Tin Man 2
Posted On: 10 Hours Ago
Replies: 225
Views: 26,679
0 What did you do for your sporty Today?
Last Post: Lone Rider
Posted On: 10 Hours Ago
Replies: 6,122
Views: 777,412
0 Occasional carb spit back, am I missing something?
Last Post: brucstoudt
Posted On: 10 Hours Ago
Replies: 29
Views: 1,032
More...
Members Birthdays
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #91  
Old 1 Week Ago
Tomcatt Tomcatt is offline
Dazed & Confused
 
Join Date: Feb 2019
Location: Never Never Land
Posts: 263
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2017
Other Motorcycle Model: BMW R Nine T
Other Motorcycle Year: 2015
Reputation: 448670
Tomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond repute
Default

Quote:
Originally Posted by Cmd11 View Post
They both have there pos and cons I have no issue with the stock one.
They're not terrible carbs but they are limited in tuning parts. It's hard to get the off idle transition right. Most just hide it by adjusting the idle overly rich.
__________________
2017 XL1200C in Wisconsin, USA
Reply With Quote
  #92  
Old 1 Week Ago
Bone's Avatar
Bone Bone is offline
Senior Master Custom Bike Builder
 
Join Date: Jun 2009
Location: Medford, NJ
Posts: 10,962
Sportster/Buell Model: 1200Lr
Sportster/Buell Year: 2007
Sportster/Buell Model #2: FLHP
Sportster/Buell Year #2: 2016
Other Motorcycle Model: 13 Guzzi V7 / 11 Duc 696
Other Motorcycle Year: 2013
Reputation: 3832855
Bone has a reputation beyond reputeBone has a reputation beyond reputeBone has a reputation beyond reputeBone has a reputation beyond reputeBone has a reputation beyond reputeBone has a reputation beyond reputeBone has a reputation beyond reputeBone has a reputation beyond reputeBone has a reputation beyond reputeBone has a reputation beyond reputeBone has a reputation beyond repute
Default

Quote:
Originally Posted by Tomcatt View Post
At higher elevations your motor is starving for air. Having the slide lift less doesn't make that better. If you're actually riding at high altitude you jet down CV carbs just like non-CV carbs. Manufacturers considered hi-altitude as being 4,000+ ft.
Despite your experience you seem to be missing a key part of the equation. Specifically how the fuel is metered by the main jet and needle.

Yes, if a CV carb is to be exclusively used at altitude you would make a change, most likely to the pilot jet and screw as the idle circuit is not effected by the main needle and vacuum diaphragm.

But the main jet and needle will meter less fuel to better match the reduced air mass/oxygen.

Again the Mikuni does not, it will deliver the same amount of fuel resulting in a much richer mixture at altitude since the needle will pull further out of the main jet than the CV in the same circumstances.
Reply With Quote
  #93  
Old 1 Week Ago
dieselvette's Avatar
dieselvette dieselvette is offline
XL FORUM TEAM MEMBER
 
Join Date: Jul 2006
Location: IOWA
Posts: 558
Sportster/Buell Model: Roadster-Glide
Sportster/Buell Year: 2004
Reputation: 38548
dieselvette is a splendid one to beholddieselvette is a splendid one to beholddieselvette is a splendid one to beholddieselvette is a splendid one to beholddieselvette is a splendid one to beholddieselvette is a splendid one to beholddieselvette is a splendid one to beholddieselvette is a splendid one to beholddieselvette is a splendid one to beholddieselvette is a splendid one to beholddieselvette is a splendid one to behold
Default

I haven't tried to keep track of who's in which pissing match, and I kinda wish that a few posts in this thread could be deleted that aren't related to carbs or EFI at all.

We're really splitting hairs here. You can look at NRHS or Hammer and see the dyno tests proving the Mikuni can make more HP, but without a doubt for cross-country riding from sea level to milehigh+ altitude and temperatures ranging 40 to 100 degrees and rain then desert, the CV carb will get you there faster (because you don't have to stop for adjustments) on less gas.

No matter what carb, if you want perfect A/F ratio 100% of the time you would have to adjust for conditions but with the CV you will do it less. So is it fair to say the HSR is better for performance, but the CV is preferred for normal every day riding?
__________________
"Life is never made unbearable by circumstances but only by lack of meaning and purpose" - Viktor Frankle

FIND HELP WITH YOUR SPORTSTER HERE: http://sportsterpedia.com/doku.php

2004 1200 Roadster Custom-Electra-Glide-Sport-Touring-Edition
SE air cleaner w/venting routed outside a/c
Supertrapp 2:1 pipe - usually 20 discs w/closed endcap
Stock CV carb w/ Yost tube + DS idle mixture screw
Cycle Electric 38A charging system
Corbin 2-up seat (plus AirHawk for LDR)
Metzler 880 front & rear (usually)
QD windshield - sometimes with SlipStreamer glass + driving lights
Custom hwy pegs - sometimes with lowers mounted
Trailer hitch, when needed

Currently working on improving MPG:
TC88A ignition
Valve job & rings - 0.030 squish, bump up compression?
Bronze oil pump gear
Update oil pump to '07-up
30-tooth HDI belt sprocket (137-tooth belt)
Reply With Quote
  #94  
Old 1 Week Ago
Tomcatt Tomcatt is offline
Dazed & Confused
 
Join Date: Feb 2019
Location: Never Never Land
Posts: 263
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2017
Other Motorcycle Model: BMW R Nine T
Other Motorcycle Year: 2015
Reputation: 448670
Tomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond reputeTomcatt has a reputation beyond repute
Default

Quote:
Originally Posted by dieselvette View Post
So is it fair to say the HSR is better for performance, but the CV is preferred for normal every day riding?
I've run both and I'd rather have the HSR for normal everyday riding. But I like my bikes to run well and don't do my jetting (or mapping) by internet polling...
Have fun. I'm done as this is clearly pointless.
Reply With Quote
  #95  
Old 6 Days Ago
DRAGONLORD69 DRAGONLORD69 is offline
Biker
 
Join Date: Jun 2019
Posts: 19
Sportster/Buell Model: XL1200CUSTOM
Sportster/Buell Year: 2006
Reputation: 10
DRAGONLORD69 is an unknown quantity at this point
Default

Quote:
Originally Posted by 60Gunner View Post
I specifically looked for a 1200C and it had to be carbed. This 05 showed up literally a mile from me 3 years ago.
yep I preferred the carbs I got one of the last carbed 1200C in black too
no wobbles i had it for 8years it was a 2006 and had just 10 thousand was just starting to smooth out when i got it

I got a great deal on it as the previous owner hardly rode it and had fallen off it at the lights at a standstill
on it when I got it its never been any trouble except for it spitting the clutch spacer rivets a couple of years back and then the throw out bearing last week i have done over 20 thousand miles on it since I had it

Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 08:28.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC