The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 Opinions (On Bike Considering Buying)
Last Post: NLXL
Posted On: 9 Minutes Ago
Replies: 5
Views: 160
0 Potential future changes for the Sportster motor?
Last Post: Nibelungen
Posted On: 37 Minutes Ago
Replies: 43
Views: 1,752
0 What's your opinion on windshields?
Last Post: boomerguy
Posted On: 1 Hour Ago
Replies: 1,247
Views: 221,316
0 ....1
Last Post: DEEP DIVER
Posted On: 1 Hour Ago
Replies: 5,813
Views: 333,878
0 79-85 Breather Vent Mod - Adding a Secondary Vent Hose at 6:00 Position
Last Post: Rolli
Posted On: 1 Hour Ago
Replies: 10
Views: 288
0 Matrix brakes
Last Post: tonystylec
Posted On: 2 Hours Ago
Replies: 0
Views: 23
0 MPG HONESTLY, what do you get?
Last Post: H.E.L.M
Posted On: 3 Hours Ago
Replies: 608
Views: 87,238
0 Do you use premium gas in your Sportster?
Last Post: XL1275
Posted On: 3 Hours Ago
Replies: 1,837
Views: 389,853
0 Hello New in the Forum
Last Post: harley506d
Posted On: 4 Hours Ago
Replies: 8
Views: 129
0 Fuel Pump Problems
Last Post: Lowe175
Posted On: 4 Hours Ago
Replies: 258
Views: 165,646
0 Hottie of the day, no nudity.
Last Post: ronccc
Posted On: 5 Hours Ago
Replies: 22,072
Views: 2,258,563
0 Ultima electronic ignition installation - Solved
Last Post: IXL2Relax
Posted On: 6 Hours Ago
Replies: 75
Views: 2,622
0 KT - 2020 - Where Eagles Dare
Last Post: IXL2Relax
Posted On: 8 Hours Ago
Replies: 60
Views: 13,820
0 Static timing
Last Post: IXL2Relax
Posted On: 9 Hours Ago
Replies: 6
Views: 268
0 Which cams ?
Last Post: rocketmangb
Posted On: 9 Hours Ago
Replies: 15
Views: 2,071
0 Anyone go racing last weekend?
Last Post: Tinz
Posted On: 9 Hours Ago
Replies: 3,222
Views: 332,431
0 Front end restoration
Last Post: Dosmie72
Posted On: 9 Hours Ago
Replies: 8
Views: 416
0 Accelerator nozzle and idle not right
Last Post: IXL2Relax
Posted On: 9 Hours Ago
Replies: 66
Views: 2,634
0 2020 east coast meet and greet.
Last Post: mick42
Posted On: 9 Hours Ago
Replies: 215
Views: 17,799
0 This is gonna hurt.
Last Post: hexnut
Posted On: 10 Hours Ago
Replies: 8,167
Views: 1,743,352
0 Kicker shaft question
Last Post: Captain Johnny
Posted On: 10 Hours Ago
Replies: 4
Views: 173
0 Spitfire motorcycle 2 into 1 Blaster
Last Post: Bmyers
Posted On: 11 Hours Ago
Replies: 0
Views: 60
0 What did you do for your sporty Today?
Last Post: NLXL
Posted On: 11 Hours Ago
Replies: 7,147
Views: 1,040,232
0 Snippets
Last Post: Crusty
Posted On: 11 Hours Ago
Replies: 239
Views: 23,960
0 Official XL Forum Random Image Thread (NO NUDITY!)
Last Post: trainman
Posted On: 11 Hours Ago
Replies: 48,375
Views: 7,799,493
0 The salty debate thread.
Last Post: NLXL
Posted On: 12 Hours Ago
Replies: 38
Views: 1,370
0 Cylinder head painting and battery and kick start advice
Last Post: Uberstorm
Posted On: 12 Hours Ago
Replies: 0
Views: 60
0 Sportster fans, tell us why!
Last Post: boomerguy
Posted On: 12 Hours Ago
Replies: 654
Views: 180,398
14 How To: View HD Part #'s 1991-2010 - All Models - With Part #'s and Exploded Views!!
Last Post: Eddie65
Posted On: 13 Hours Ago
Replies: 86
Views: 65,731
0 Do you have the service manual?
Last Post: MikeBel
Posted On: 13 Hours Ago
Replies: 766
Views: 216,851
More...
Members Birthdays
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,993
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4475060
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch (now with Barnett Pressure plate and 25% stiffer spring)
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,993
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4475060
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,953
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1723729
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)


Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch, Energy One 15% heavier spring, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from 2012 street glide w/ matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

Dyno Sheet
96.21 HP/88.70 TQ


States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,993
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4475060
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT +1. The time now is 12:05.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC