The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > DYNO Charts and Result
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

DYNO Charts and Result Post your dyno charts and results here.

Active Threads
0 Hottie of the day, no nudity.
Last Post: Nibelungen
Posted On: 3 Minutes Ago
Replies: 23,305
Views: 2,375,990
0 compression test question
Last Post: kitabel
Posted On: 8 Minutes Ago
Replies: 9
Views: 95
0 Vulcan Mid Glide Triple Tree Conversion Set
Last Post: Dariusz
Posted On: 20 Minutes Ago
Replies: 1
Views: 68
0 New oil tank
Last Post: Hippysmack
Posted On: 21 Minutes Ago
Replies: 126
Views: 5,733
0 Fork seal follow up...Stop me if I'm being stupid.
Last Post: Glas482
Posted On: 31 Minutes Ago
Replies: 0
Views: 1
0 Sportster 48 in a Nighster
Last Post: motorfish
Posted On: 34 Minutes Ago
Replies: 1
Views: 33
0 Early Sportster XLCH 900 Dyno Run
Last Post: Ferrous Head
Posted On: 35 Minutes Ago
Replies: 112
Views: 32,638
0 top end rebuild
Last Post: needspeed
Posted On: 37 Minutes Ago
Replies: 83
Views: 4,505
0 Keep & Kill
Last Post: Graywolf
Posted On: 38 Minutes Ago
Replies: 18,423
Views: 1,094,323
0 Halloween 1250 Conversion
Last Post: John Harper
Posted On: 45 Minutes Ago
Replies: 15
Views: 766
0 Do not buy this oil!
Last Post: Ferrous Head
Posted On: 46 Minutes Ago
Replies: 51
Views: 1,911
0 Not a Sporty Carb..but CV
Last Post: npaisnel
Posted On: 48 Minutes Ago
Replies: 8
Views: 454
0 07 Ign Acc position.
Last Post: npaisnel
Posted On: 53 Minutes Ago
Replies: 6
Views: 186
0 IH Crankcase Pressure and Engine Breathing
Last Post: brucstoudt
Posted On: 54 Minutes Ago
Replies: 96
Views: 4,381
0 Swing arm pivot
Last Post: motorfish
Posted On: 1 Hour Ago
Replies: 5
Views: 77
0 XLH 900 1969 Build Thread
Last Post: doodah man
Posted On: 2 Hours Ago
Replies: 18
Views: 390
0 Clutch blow up
Last Post: wedge
Posted On: 2 Hours Ago
Replies: 11
Views: 246
0 Oil leaking
Last Post: Zari
Posted On: 2 Hours Ago
Replies: 20
Views: 848
0 random rattle
Last Post: RicThompson
Posted On: 2 Hours Ago
Replies: 14
Views: 627
3 Wtb, Wts, Wtt, Wtg (Buells)
Last Post: Folkie
Posted On: 2 Hours Ago
Replies: 1
Views: 13,401
0 BEWARE Of SCAMMERS!
Last Post: Folkie
Posted On: 2 Hours Ago
Replies: 0
Views: 61
3 Wtb, Wts, Wtt, Wtg (XRs)
Last Post: Folkie
Posted On: 2 Hours Ago
Replies: 1
Views: 7,888
3 Wtb, Wts, Wtt, Wtg (EFIs)
Last Post: Folkie
Posted On: 2 Hours Ago
Replies: 2
Views: 76,548
3 Wtb, Wts, Wtt, Wtg (Rubber Mounts)
Last Post: Folkie
Posted On: 2 Hours Ago
Replies: 13
Views: 45,963
3 Wtb, Wts, Wtt, Wtg (Evos)
Last Post: Folkie
Posted On: 3 Hours Ago
Replies: 16
Views: 81,709
0 You got to be kidding!
Last Post: sportsterdoc
Posted On: 3 Hours Ago
Replies: 4
Views: 127
3 Wtb, Wts, Wtt, Wtg (Ironhead)
Last Post: Folkie
Posted On: 3 Hours Ago
Replies: 36
Views: 267,756
0 1986 Adjustable Push Rod Adjustment
Last Post: 109Countries
Posted On: 3 Hours Ago
Replies: 20
Views: 342
0 My frist question...Fork seal replacement
Last Post: ericfreeman
Posted On: 3 Hours Ago
Replies: 9
Views: 366
0 Do you have the service manual?
Last Post: MikeBel
Posted On: 3 Hours Ago
Replies: 766
Views: 219,444
More...
Members Birthdays
seajay, Hugh Betcha (74), jimhd89 (71), JayFL459 (71), Big Al (64), dakota_dj (63), 10walt (61), kiltbill (61), timsvalk (60), horsewriter (55), Benetampa (43), hobson8494 (36), Joker8494 (36), 8ball (31)
Reply
 
Share Thread Tools Display Modes
  #1  
Old 15th May 2017
aswracing's Avatar
aswracing aswracing is offline
A Million Facts & Figures
 
Join Date: Jan 2005
Location: Famous Potatoes
Posts: 10,230
Sportster/Buell Model: XL883
Sportster/Buell Year: 2007
Sportster/Buell Model #2: Buell Cyclone
Sportster/Buell Year #2: 1999
Reputation: 3020857
aswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond repute
Default Somewhat interesting 1275 result



2003 XL883R owned by a Valued HAMMER PERFORMANCE customer, equipped as follows:
Very good result for STOCK Thunderstorm heads. Back in the day, when Buells came with these same heads and cams, a good one would turn 90hp, I tested tons of them on this same dyno. So to get 96ish on a Sportster, with it's heavier flywheels to boot, is doing well. The 1275 kit has a bit to do with that.

As is plainly visible in the chart, the pipe is reverting badly below 3000 rpm. The torque is low, and with a small measurement lag, the AFR goes fat. Those are both sure signs of a pipe that's reverting.

What happens is the pipe pushes back during the overlap window, i.e. when the exhaust is connected to the carb. The intake charge that's sitting in the ports and manifold get shoved right back out the carb. Then the piston goes down and sucks it back in again. So you get a charge that's been through the carb three times - in, out, back in again - picking up fuel each time, and the motor goes rich. Plus you get a big hole in the torque curve because the cylinder fill is so bad. One tell-tale sign that you're reverting is a fog of fuel standing outside the carb.

The above chart was done with a 165 main in the Mik. On the right side of the chart, it wanted more main jet. In fact, with more main in place and taking it to 6800, I hit 98hp and 92lb-ft of torque a couple times. However, putting anything bigger than the 165 into the carb made it shoot ducks in the reversion. I didn't want to deliver the bike with that going on, so I settled on the 165. That was the biggest jet it would take without breaking up in the reversion.

Being a pipe issue, the right way to fix this is on the pipe side. There are ways to try to address it on the carb side, for example Thunderjets with less main, but at the end of the day that's a crutch. It's really a pipe issue.

Makes you appreciate EFI. You can't fix the reversion with EFI, but you can at least keep it from going fat.

The pipe follows the reversion with a real hard pull through the mid range, dying on top. In other words, not real great diffusion. A lot of pipes behave this way.

I'd be surprised if I couldn't hit 100 with a Patriot in place, with it's big top end punch.

(Hey Folkie ... there's no sticky reference thread for 1275's ... hint hint)
__________________
Click Here to Contact Me

Reply With Quote
  #2  
Old 11th July 2017
TT60 TT60 is offline
Chief Harley Engineer
 
Join Date: Nov 2010
Posts: 536
Reputation: 68455
TT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud of
Default

Looks like my Winter project will be 1275 kit

Just gotta save my pennies now.
Reply With Quote
  #3  
Old 30th September 2019
Highly-Dangerous's Avatar
Highly-Dangerous Highly-Dangerous is offline
Senior Chief Know It All 2nd Class
 
Join Date: Apr 2019
Location: 17130 Spain
Posts: 1,455
Sportster/Buell Model: XL 883 ₪ 1275
Sportster/Buell Year: 2006
Other Motorcycle Model: Big Dog K9
Other Motorcycle Year: 2006
Reputation: 3578423
Highly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond repute
Default

Wow!!! Those were very good numbers!!!

I am in the process of ordering the 1275.... I keep wondering about my stock heads... I am worried about regretting it in the future.
__________________
[B][COLOR="Red"]CLICK->>[/COLOR][URL="http://sportsterpedia.com/doku.php/start"]"Maintenance is as much art as it is science"[/URL][COLOR="red"]<<-CLICK[/COLOR][/B]

[IMG]http://xlforum.net/forums/attachment.php?attachmentid=20617&d=1576580635[/IMG]
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT +1. The time now is 00:33.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC