The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 100 vs 110 front tire
Last Post: glbsportster
Posted On: 28 Minutes Ago
Replies: 127
Views: 77,883
0 2009 XL1200N, want to install factory dual guages from 01, need help
Last Post: IXL2Relax
Posted On: 32 Minutes Ago
Replies: 34
Views: 1,419
0 09 Alarm / Siren / Regulator issues
Last Post: IXL2Relax
Posted On: 41 Minutes Ago
Replies: 28
Views: 500
0 Hottie of the day, no nudity.
Last Post: trainman
Posted On: 54 Minutes Ago
Replies: 24,211
Views: 2,476,113
0 Upside Down Monoshock IH - A Longterm Project
Last Post: ryder rick
Posted On: 1 Hour Ago
Replies: 238
Views: 44,200
0 Keep & Kill
Last Post: Crusty
Posted On: 1 Hour Ago
Replies: 18,831
Views: 1,119,538
0 Snippets
Last Post: Crusty
Posted On: 1 Hour Ago
Replies: 316
Views: 35,045
0 82 XLH struggling for power
Last Post: 72 Ironhead XLH
Posted On: 1 Hour Ago
Replies: 4
Views: 109
0 What did you do for your sporty Today?
Last Post: boomerguy
Posted On: 1 Hour Ago
Replies: 7,340
Views: 1,087,835
0 -65A mufflers
Last Post: ferretface
Posted On: 1 Hour Ago
Replies: 5
Views: 318
0 Better Brakes
Last Post: mikethebike61
Posted On: 1 Hour Ago
Replies: 18
Views: 1,001
0 Swap from electronic ign. to points?
Last Post: mikethebike61
Posted On: 2 Hours Ago
Replies: 26
Views: 2,946
0 carbs?
Last Post: Ferrous Head
Posted On: 2 Hours Ago
Replies: 29
Views: 4,929
0 Newbie
Last Post: Ferrous Head
Posted On: 2 Hours Ago
Replies: 47
Views: 1,196
0 Lets see your off season builds
Last Post: madnss
Posted On: 2 Hours Ago
Replies: 1,451
Views: 216,336
0 What about these cheap CV carb kits?
Last Post: Ferrous Head
Posted On: 2 Hours Ago
Replies: 34
Views: 2,276
0 How-To: Eliminate the Turn Signal Module (TSM)
Last Post: jon1966uk
Posted On: 2 Hours Ago
Replies: 248
Views: 107,306
0 Tools
Last Post: Robyart
Posted On: 2 Hours Ago
Replies: 8
Views: 316
0 MS rollers way too tight
Last Post: Ferrous Head
Posted On: 3 Hours Ago
Replies: 32
Views: 1,450
0 Which motorcycles do you wish you kept or would like to again own?
Last Post: sportsterdoc
Posted On: 3 Hours Ago
Replies: 28
Views: 871
0 Zippers 1250 kit
Last Post: wardie
Posted On: 8 Hours Ago
Replies: 4
Views: 179
0 my daily driver
Last Post: 84rzv500r
Posted On: 8 Hours Ago
Replies: 13
Views: 2,333
0 "The Blues" thread!
Last Post: rokytnji
Posted On: 10 Hours Ago
Replies: 967
Views: 101,619
0 OEM Headlight Bucket?
Last Post: spoon
Posted On: 10 Hours Ago
Replies: 7
Views: 309
0 Hot Chicks on Hot Bikes
Last Post: trainman
Posted On: 10 Hours Ago
Replies: 11,365
Views: 2,281,438
0 KBS tank sealer
Last Post: mrmom9r
Posted On: 11 Hours Ago
Replies: 1
Views: 232
0 Official XL Forum Random Image Thread (NO NUDITY!)
Last Post: Stairman
Posted On: 13 Hours Ago
Replies: 48,905
Views: 7,929,677
0 mainshaft rollers size
Last Post: Steve9
Posted On: 14 Hours Ago
Replies: 49
Views: 2,430
0 $10 for an oil change VR1 20W50 conventional
Last Post: PappaBravo
Posted On: 19 Hours Ago
Replies: 4
Views: 501
0 Iree's late night cafe
Last Post: rokytnji
Posted On: 20 Hours Ago
Replies: 1,780
Views: 249,385
More...
Members Birthdays
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 22,100
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4480792
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch (now with Barnett Pressure plate and 25% stiffer spring)
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 22,100
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4480792
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,951
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1723729
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)


Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch, Energy One 15% heavier spring, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from 2012 street glide w/ matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

Dyno Sheet
96.21 HP/88.70 TQ


States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 22,100
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4480792
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT +1. The time now is 02:57.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC