The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 Wild Crap Going on Today On My Ride
Last Post: XL1275
Posted On: 17 Minutes Ago
Replies: 0
Views: 1
0 Kick starter resistance
Last Post: metal88
Posted On: 19 Minutes Ago
Replies: 8
Views: 92
0 79-85 Breather Vent Mod - Adding a Secondary Vent Hose at 6:00 Position
Last Post: Bluto
Posted On: 39 Minutes Ago
Replies: 7
Views: 146
0 Potential future changes for the Sportster motor?
Last Post: kitabel
Posted On: 40 Minutes Ago
Replies: 36
Views: 1,475
0 Kicker shaft question
Last Post: Captain Johnny
Posted On: 41 Minutes Ago
Replies: 0
Views: 3
0 Question for Jorgen, Aaron, ???
Last Post: Maxeffort
Posted On: 1 Hour Ago
Replies: 2
Views: 277
0 Hot Chicks on Hot Bikes
Last Post: trainman
Posted On: 1 Hour Ago
Replies: 11,055
Views: 2,169,274
0 Sportster fans, tell us why!
Last Post: 1200CustomHD
Posted On: 2 Hours Ago
Replies: 651
Views: 180,112
0 Ultima electronic ignition installation - Solved
Last Post: darwin-t
Posted On: 3 Hours Ago
Replies: 71
Views: 2,490
0 What did you do for your sporty Today?
Last Post: Maxeffort
Posted On: 3 Hours Ago
Replies: 7,143
Views: 1,039,448
0 Official XL Forum Random Image Thread (NO NUDITY!)
Last Post: Graywolf
Posted On: 3 Hours Ago
Replies: 48,374
Views: 7,798,105
0 Food porn
Last Post: Graywolf
Posted On: 3 Hours Ago
Replies: 2,085
Views: 409,682
0 $700 Ironhead ? Good value? depends who you ask
Last Post: the cowboy way
Posted On: 3 Hours Ago
Replies: 43
Views: 2,486
0 tapped adjust
Last Post: IronMick
Posted On: 4 Hours Ago
Replies: 4
Views: 109
0 Do you blip the throttle when downshifting?
Last Post: iNSaNeSHaNe
Posted On: 4 Hours Ago
Replies: 472
Views: 85,739
0 Hottie of the day, no nudity.
Last Post: Stairman
Posted On: 4 Hours Ago
Replies: 22,059
Views: 2,257,304
0 19" Tire w/23" Overall Diameter???
Last Post: XL1275
Posted On: 5 Hours Ago
Replies: 2
Views: 108
0 Starter solenoid short
Last Post: Bwf347
Posted On: 5 Hours Ago
Replies: 5
Views: 181
5 Request advice - Engine knock above 2800rpm
Last Post: XL Dane
Posted On: 6 Hours Ago
Replies: 17
Views: 625
0 Keep & Kill
Last Post: Crusty
Posted On: 7 Hours Ago
Replies: 18,096
Views: 1,066,993
0 what brand of spark plug do you use?
Last Post: Billy1200
Posted On: 7 Hours Ago
Replies: 335
Views: 84,455
0 The salty debate thread.
Last Post: DEEP DIVER
Posted On: 9 Hours Ago
Replies: 37
Views: 972
0 Sportster engine wt.
Last Post: bustert
Posted On: 9 Hours Ago
Replies: 10
Views: 399
0 Why Torx?
Last Post: bustert
Posted On: 9 Hours Ago
Replies: 19
Views: 798
0 Do you use premium gas in your Sportster?
Last Post: Hellbent_4
Posted On: 10 Hours Ago
Replies: 1,836
Views: 389,767
0 Town Bike Handlebar Styling
Last Post: harley506d
Posted On: 11 Hours Ago
Replies: 1
Views: 76
0 WTF Happened
Last Post: iNSaNeSHaNe
Posted On: 11 Hours Ago
Replies: 1,247
Views: 212,222
0 EFI Sporty Hanging Revs
Last Post: gwd1994
Posted On: 13 Hours Ago
Replies: 15
Views: 347
0 Hello
Last Post: Toejam503
Posted On: 15 Hours Ago
Replies: 12
Views: 160
0 Range With EFI 3.3 Gal Tank
Last Post: Nibelungen
Posted On: 16 Hours Ago
Replies: 96
Views: 64,879
More...
Members Birthdays
ziggyhd1 (62), MikeDelta (62), greven (60), bliynd (35), Steveb1990 (30)
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,991
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4475060
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch (now with Barnett Pressure plate and 25% stiffer spring)
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,991
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4475060
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,953
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1723729
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)


Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch, Energy One 15% heavier spring, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from 2012 street glide w/ matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

Dyno Sheet
96.21 HP/88.70 TQ


States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,991
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4475060
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT +1. The time now is 19:33.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC