The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 Krome Werks HP Plus slipons - Replacements ?
Last Post: npaisnel
Posted On: 9 Minutes Ago
Replies: 0
Views: 1
0 How many have converted their 883 to 1200?
Last Post: npaisnel
Posted On: 17 Minutes Ago
Replies: 395
Views: 110,355
2 My 1275 Hammer Conversion..
Last Post: carbonizedeyesockets
Posted On: 2 Hours Ago
Replies: 123
Views: 5,507
0 EFI conversion on an '05 1200c??
Last Post: kdanie
Posted On: 5 Hours Ago
Replies: 5
Views: 135
0 Frankenbrakes
Last Post: rocketmangb
Posted On: 5 Hours Ago
Replies: 1
Views: 45
0 In tank fuel filter on 2004 xlc
Last Post: sportsterpaul
Posted On: 5 Hours Ago
Replies: 5
Views: 141
0 New Buell Rider From Southern MN
Last Post: sportsterpaul
Posted On: 5 Hours Ago
Replies: 11
Views: 191
0 Hi from Barcelona!
Last Post: sportsterpaul
Posted On: 5 Hours Ago
Replies: 11
Views: 324
0 Snippets
Last Post: Crusty
Posted On: 5 Hours Ago
Replies: 20
Views: 1,796
0 im sure its been done to death trans fluid
Last Post: sportsterpaul
Posted On: 6 Hours Ago
Replies: 12
Views: 438
0 How tricky is it to replace dipstick trim from oil tank?
Last Post: sportsterpaul
Posted On: 6 Hours Ago
Replies: 10
Views: 470
0 Too HOT to ride?
Last Post: sportsterpaul
Posted On: 6 Hours Ago
Replies: 340
Views: 27,655
0 Keep & Kill
Last Post: Crusty
Posted On: 6 Hours Ago
Replies: 15,644
Views: 879,678
0 Still having trouble starting the 61xlh
Last Post: Hopalong48
Posted On: 7 Hours Ago
Replies: 2
Views: 84
0 Leineweber camshaft
Last Post: Iron Mike
Posted On: 7 Hours Ago
Replies: 108
Views: 7,218
0 Do you use premium gas in your Sportster?
Last Post: Kbetts
Posted On: 7 Hours Ago
Replies: 1,807
Views: 375,768
0 Broke my drive belt (Stay With The Belt Or Do A Chain Conversion?)
Last Post: Folkie
Posted On: 8 Hours Ago
Replies: 90
Views: 23,849
0 Battery cable length
Last Post: IronMick
Posted On: 8 Hours Ago
Replies: 1
Views: 86
0 Hottie of the day, no nudity.
Last Post: trainman
Posted On: 9 Hours Ago
Replies: 16,866
Views: 1,673,429
0 su carb question
Last Post: kitabel
Posted On: 9 Hours Ago
Replies: 37
Views: 1,193
0 photo size
Last Post: Folkie
Posted On: 9 Hours Ago
Replies: 6
Views: 202
0 Shifter shaft seal.
Last Post: Hippysmack
Posted On: 9 Hours Ago
Replies: 59
Views: 10,725
0 XL FORUM Offcial Sciatica Thread
Last Post: sportsterpaul
Posted On: 10 Hours Ago
Replies: 54
Views: 20,582
0 Anyone carry a gun while riding ?
Last Post: ChinCactus
Posted On: 10 Hours Ago
Replies: 453
Views: 82,034
0 Hot Rods, Rat Rods, and Customs.
Last Post: Stairman
Posted On: 11 Hours Ago
Replies: 3,949
Views: 519,216
0 my recent ebay purchase
Last Post: brucstoudt
Posted On: 11 Hours Ago
Replies: 30
Views: 1,838
0 Whats your carry gun?
Last Post: burely
Posted On: 12 Hours Ago
Replies: 697
Views: 105,288
0 Official XL Forum Random Image Thread (NO NUDITY!)
Last Post: Graywolf
Posted On: 12 Hours Ago
Replies: 46,387
Views: 7,374,254
0 Hello from Northern Alberta
Last Post: Hardtailer
Posted On: 12 Hours Ago
Replies: 17
Views: 343
0 Noise from Primary. Bike with extremely low miles
Last Post: Lolzcat
Posted On: 13 Hours Ago
Replies: 16
Views: 557
More...
Members Birthdays
hubbinator (71), sport53 (67), kship (55), jrmkel (41), IR88n3 (36), waltweezy45 (33), lumberjack (30)
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,536
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4223613
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch (now with Barnett Pressure plate and 25% stiffer spring)
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,536
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4223613
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,836
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1570647
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)


Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch, Energy One 15% heavier spring, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from 2012 street glide w/ matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

Dyno Sheet
96.21 HP/88.70 TQ


States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,536
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4223613
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 10:55.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC