The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 Topend problem
Last Post: doodah man
Posted On: 3 Minutes Ago
Replies: 9
Views: 137
0 What gas mileage do you get for touring?
Last Post: Graywolf
Posted On: 16 Minutes Ago
Replies: 134
Views: 45,299
0 S&S pushrod adjustment
Last Post: T_worth
Posted On: 34 Minutes Ago
Replies: 18
Views: 430
0 Does Synthetic Engine Oil cause Higher or Lower temps at the oil tank?
Last Post: 60Gunner
Posted On: 39 Minutes Ago
Replies: 84
Views: 16,350
0 New problem with 1200s (Rev Limiter)
Last Post: ftwflh
Posted On: 40 Minutes Ago
Replies: 23
Views: 817
0 Suzuki Lights On 883
Last Post: IXL2Relax
Posted On: 44 Minutes Ago
Replies: 69
Views: 1,438
0 Magnaflow F-Bomb on a Rigid?
Last Post: t120r
Posted On: 45 Minutes Ago
Replies: 0
Views: 1
9 Aftermarket Petcocks
Last Post: ezmerf
Posted On: 46 Minutes Ago
Replies: 13
Views: 463
0 Motorcycle oils or not ?
Last Post: hexnut
Posted On: 47 Minutes Ago
Replies: 69
Views: 2,088
14 Where do you store your Sportster over the winter?
Last Post: XLPIZZA
Posted On: 55 Minutes Ago
Replies: 48
Views: 2,079
0 How many when You park.... (Leave Your Bike In Gear)
Last Post: SLW210
Posted On: 1 Hour Ago
Replies: 353
Views: 43,293
0 How many members near San Bernardino ?
Last Post: WheelmanKME
Posted On: 1 Hour Ago
Replies: 6
Views: 377
0 Front brake shorting?
Last Post: wedge
Posted On: 1 Hour Ago
Replies: 12
Views: 226
0 What are your thoughts on this 2004 rubbermount Sporty?
Last Post: wedge
Posted On: 1 Hour Ago
Replies: 60
Views: 2,317
0 68 ch mag problems
Last Post: Ferrous Head
Posted On: 1 Hour Ago
Replies: 11
Views: 324
0 Occasionally pops out of 2nd
Last Post: Ferrous Head
Posted On: 2 Hours Ago
Replies: 3
Views: 161
6 Is Your SPORTSTER...
Last Post: Toejam503
Posted On: 2 Hours Ago
Replies: 7
Views: 1,171
0 Another ironhead roadracer
Last Post: Ferrous Head
Posted On: 2 Hours Ago
Replies: 20
Views: 824
0 Recommendations for a good parts vendor
Last Post: brucstoudt
Posted On: 2 Hours Ago
Replies: 13
Views: 530
0 Anyone try the new Conti tour tires
Last Post: c1skout
Posted On: 2 Hours Ago
Replies: 3
Views: 73
0 '71 XLCH starting issues, any ideas?
Last Post: brucstoudt
Posted On: 2 Hours Ago
Replies: 20
Views: 437
0 Patriot Defender whats the next best exhaust?
Last Post: Segway
Posted On: 3 Hours Ago
Replies: 152
Views: 26,319
0 What did you do for your sporty Today?
Last Post: dodgetrucken
Posted On: 4 Hours Ago
Replies: 5,446
Views: 622,609
0 A Day in the Life...
Last Post: SLW210
Posted On: 4 Hours Ago
Replies: 584
Views: 55,176
0 Another spark plug question...
Last Post: wedge
Posted On: 4 Hours Ago
Replies: 15
Views: 529
0 Photos: King Peanut or Regular Peanut tank?
Last Post: bimbo
Posted On: 4 Hours Ago
Replies: 44
Views: 20,143
0 DK's Definitive Ride Report - Some of the Best Scenic Roads Out West - Tons of Photo'
Last Post: DK Custom
Posted On: 4 Hours Ago
Replies: 174
Views: 10,537
0 hi guys kiwi from australia...we make more money over here
Last Post: jharback
Posted On: 4 Hours Ago
Replies: 8
Views: 146
0 how thick is your backbone?
Last Post: bimbo
Posted On: 5 Hours Ago
Replies: 0
Views: 55
5 Favourite grips?
Last Post: Stairman
Posted On: 6 Hours Ago
Replies: 50
Views: 8,888
More...
Members Birthdays
doughboy (65), tinman (63), mofo (56), JAFI (55), Topgun (53), Hogwylde (53), Pay Toilet (52), grwhite038 (50), JWG883 (49), sorryifitburns (45), Leibniz (43), higgins14 (41)
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,537
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2679679
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,537
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2679679
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,620
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1154533
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)



Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch with Energy One 15% heavier spring plate, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from a 2012 street glide with matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,537
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2679679
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 00:50.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC