The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > DYNO Charts and Result
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

DYNO Charts and Result Post your dyno charts and results here.

Active Threads
0 Carburetor opinions
Last Post: juzyHD
Posted On: 1 Minute Ago
Replies: 25
Views: 716
0 Lets See your bike on a scenic overlook
Last Post: Graywolf
Posted On: 1 Hour Ago
Replies: 140
Views: 25,541
0 rotating engine by hand
Last Post: Hippysmack
Posted On: 1 Hour Ago
Replies: 5
Views: 109
0 KT - 2019 - Done Riding - Not Hardly
Last Post: Hippysmack
Posted On: 1 Hour Ago
Replies: 108
Views: 10,507
0 Collapsed lifter??
Last Post: Hippysmack
Posted On: 1 Hour Ago
Replies: 74
Views: 2,344
0 Got a Sick Piggy. Only Running on Choke and Restarts on Reserve?
Last Post: jharback
Posted On: 1 Hour Ago
Replies: 5
Views: 246
0 New to 2002 hugger 883
Last Post: jharback
Posted On: 1 Hour Ago
Replies: 6
Views: 175
0 Hello from Az
Last Post: Greasypigeon
Posted On: 1 Hour Ago
Replies: 17
Views: 227
0 Do you use premium gas in your Sportster?
Last Post: motorend
Posted On: 1 Hour Ago
Replies: 1,788
Views: 367,494
0 Hi from North Wales, UK
Last Post: jharback
Posted On: 1 Hour Ago
Replies: 4
Views: 68
0 XLCH Crazy voltage spike
Last Post: Seeny
Posted On: 2 Hours Ago
Replies: 37
Views: 1,524
0 HD by Italian east coast
Last Post: sportsterpaul
Posted On: 2 Hours Ago
Replies: 5
Views: 96
0 Keep & Kill
Last Post: moparnut72
Posted On: 3 Hours Ago
Replies: 13,944
Views: 781,919
0 IT"S "dodgetrucken"s BIRTHDAY!!!
Last Post: Yakcm2
Posted On: 3 Hours Ago
Replies: 2
Views: 113
0 1960 XLCH in the UK
Last Post: sportsterpaul
Posted On: 3 Hours Ago
Replies: 152
Views: 14,477
0 Crusty's Travels
Last Post: sportsterpaul
Posted On: 4 Hours Ago
Replies: 2,483
Views: 322,628
0 Transmission Issue or clutch?
Last Post: doodah man
Posted On: 4 Hours Ago
Replies: 23
Views: 964
0 Daniel Boone controls
Last Post: Maxeffort
Posted On: 4 Hours Ago
Replies: 5
Views: 91
0 Hottie of the day, no nudity.
Last Post: trainman
Posted On: 6 Hours Ago
Replies: 14,435
Views: 1,344,563
0 Iree's late night cafe
Last Post: rubine
Posted On: 7 Hours Ago
Replies: 1,319
Views: 167,172
0 Fitment between 2005 & 2006
Last Post: XL Ed
Posted On: 7 Hours Ago
Replies: 31
Views: 1,717
0 Wiring Diagram in autocad
Last Post: IXL2Relax
Posted On: 7 Hours Ago
Replies: 94
Views: 45,250
0 Wet Sump Ifo, fix and tools
Last Post: Ferrous Head
Posted On: 9 Hours Ago
Replies: 51
Views: 3,427
0 Change jets without removing carb?
Last Post: Folkie
Posted On: 9 Hours Ago
Replies: 24
Views: 4,064
0 Need help desperately rewiring the front of my bike
Last Post: bustert
Posted On: 9 Hours Ago
Replies: 4
Views: 183
0 Mild 1250 build thoughts?
Last Post: Ghostdog
Posted On: 9 Hours Ago
Replies: 82
Views: 2,444
0 Talking dog
Last Post: Davo_137
Posted On: 10 Hours Ago
Replies: 3
Views: 258
0 What did you do for your sporty Today?
Last Post: Boil1337
Posted On: 10 Hours Ago
Replies: 6,419
Views: 830,325
More...
Members Birthdays
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #1  
Old 15th May 2017
aswracing's Avatar
aswracing aswracing is offline
A Million Facts & Figures
 
Join Date: Jan 2005
Location: Famous Potatoes
Posts: 10,058
Sportster/Buell Model: XL883
Sportster/Buell Year: 2007
Sportster/Buell Model #2: Buell Cyclone
Sportster/Buell Year #2: 1999
Reputation: 2674312
aswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond reputeaswracing has a reputation beyond repute
Default Somewhat interesting 1275 result



2003 XL883R owned by a Valued HAMMER PERFORMANCE customer, equipped as follows:
Very good result for STOCK Thunderstorm heads. Back in the day, when Buells came with these same heads and cams, a good one would turn 90hp, I tested tons of them on this same dyno. So to get 96ish on a Sportster, with it's heavier flywheels to boot, is doing well. The 1275 kit has a bit to do with that.

As is plainly visible in the chart, the pipe is reverting badly below 3000 rpm. The torque is low, and with a small measurement lag, the AFR goes fat. Those are both sure signs of a pipe that's reverting.

What happens is the pipe pushes back during the overlap window, i.e. when the exhaust is connected to the carb. The intake charge that's sitting in the ports and manifold get shoved right back out the carb. Then the piston goes down and sucks it back in again. So you get a charge that's been through the carb three times - in, out, back in again - picking up fuel each time, and the motor goes rich. Plus you get a big hole in the torque curve because the cylinder fill is so bad. One tell-tale sign that you're reverting is a fog of fuel standing outside the carb.

The above chart was done with a 165 main in the Mik. On the right side of the chart, it wanted more main jet. In fact, with more main in place and taking it to 6800, I hit 98hp and 92lb-ft of torque a couple times. However, putting anything bigger than the 165 into the carb made it shoot ducks in the reversion. I didn't want to deliver the bike with that going on, so I settled on the 165. That was the biggest jet it would take without breaking up in the reversion.

Being a pipe issue, the right way to fix this is on the pipe side. There are ways to try to address it on the carb side, for example Thunderjets with less main, but at the end of the day that's a crutch. It's really a pipe issue.

Makes you appreciate EFI. You can't fix the reversion with EFI, but you can at least keep it from going fat.

The pipe follows the reversion with a real hard pull through the mid range, dying on top. In other words, not real great diffusion. A lot of pipes behave this way.

I'd be surprised if I couldn't hit 100 with a Patriot in place, with it's big top end punch.

(Hey Folkie ... there's no sticky reference thread for 1275's ... hint hint)
__________________
Click Here to Contact Me

Reply With Quote
  #2  
Old 11th July 2017
TT60 TT60 is offline
Chief Harley Engineer
 
Join Date: Nov 2010
Posts: 536
Reputation: 68455
TT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud ofTT60 has much to be proud of
Default

Looks like my Winter project will be 1275 kit

Just gotta save my pennies now.
Reply With Quote
  #3  
Old 2 Weeks Ago
Highly-Dangerous's Avatar
Highly-Dangerous Highly-Dangerous is offline
SPANIARD
 
Join Date: Apr 2019
Location: 17130 Spain
Posts: 455
Sportster/Buell Model: XL 883
Sportster/Buell Year: 2006
Other Motorcycle Model: Big Dog K9
Other Motorcycle Year: 2006
Reputation: 1083150
Highly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond reputeHighly-Dangerous has a reputation beyond repute
Default

Wow!!! Those were very good numbers!!!

I am in the process of ordering the 1275.... I keep wondering about my stock heads... I am worried about regretting it in the future.
__________________
CLICK->>"Maintenance is as much art as it is science"<<-CLICK

Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 08:18.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC