The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE FORUM > Sportster Motorcycle Era Specific and Model Specific > Rubber Mount Sportster Motorcycle Talk (2004-2006)
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

Rubber Mount Sportster Motorcycle Talk (2004-2006) This area is to discuss issues, problems and anything else unique to the 2004 and above Sportster motorcycles

Active Threads
0 Keep & Kill
Last Post: Crusty
Posted On: 1 Minute Ago
Replies: 29,225
Views: 1,705,628
0 Allegheny National Park III
Last Post: sportsterpaul
Posted On: 1 Minute Ago
Replies: 194
Views: 19,244
5 Ever Have Days Where You Can't Stand Your Significant Other?
Last Post: Steve9
Posted On: 16 Minutes Ago
Replies: 162
Views: 31,608
0 Short in the turn signals, opened it up, brass fell out?
Last Post: Debute23
Posted On: 19 Minutes Ago
Replies: 0
Views: 1
0 pop's through carb at,idle
Last Post: Racepres
Posted On: 20 Minutes Ago
Replies: 19
Views: 5,129
0 Oh deer
Last Post: Steve9
Posted On: 43 Minutes Ago
Replies: 19
Views: 1,049
0 What makes a Hugger a Hugger?
Last Post: rejeanprimeau
Posted On: 44 Minutes Ago
Replies: 9
Views: 181
0 an old Lady
Last Post: lehel
Posted On: 1 Hour Ago
Replies: 3
Views: 286
0 2007 1200 low idle when hot...
Last Post: kuch73
Posted On: 2 Hours Ago
Replies: 0
Views: 10
0 Gas Cap problem?
Last Post: ZTatZAU
Posted On: 2 Hours Ago
Replies: 58
Views: 1,974
0 video & pics
Last Post: BKB
Posted On: 2 Hours Ago
Replies: 1,391
Views: 142,124
0 Can't install pushrod cover
Last Post: Iron Mike
Posted On: 3 Hours Ago
Replies: 8
Views: 131
0 oil light flickering
Last Post: stewart
Posted On: 3 Hours Ago
Replies: 12
Views: 247
0 Hottie of the day, no nudity.
Last Post: Stairman
Posted On: 3 Hours Ago
Replies: 36,975
Views: 4,579,200
5 Are you married or single???
Last Post: Steve9
Posted On: 3 Hours Ago
Replies: 538
Views: 79,118
0 Coffee serving
Last Post: Stairman
Posted On: 4 Hours Ago
Replies: 0
Views: 52
10 Future hardtail springer.
Last Post: sportsterpaul
Posted On: 4 Hours Ago
Replies: 29
Views: 12,118
0 Chain conversion
Last Post: sportsterpaul
Posted On: 4 Hours Ago
Replies: 1
Views: 66
0 What did you do for your sporty Today?
Last Post: sportsterpaul
Posted On: 4 Hours Ago
Replies: 7,996
Views: 1,449,715
0 Factory Chain Oiler
Last Post: Doc308
Posted On: 8 Hours Ago
Replies: 15
Views: 473
0 1981 XLH Getting Recranked
Last Post: owlsplace
Posted On: 8 Hours Ago
Replies: 105
Views: 5,200
0 Hand brake for rear drum
Last Post: mrmom9r
Posted On: 8 Hours Ago
Replies: 1
Views: 159
0 Roads I'd like to ride.
Last Post: Stairman
Posted On: 9 Hours Ago
Replies: 3,837
Views: 474,987
0 Official XL Forum Random Image Thread (NO NUDITY!)
Last Post: Stairman
Posted On: 12 Hours Ago
Replies: 54,426
Views: 9,256,378
0 This week on Craig's list
Last Post: camojoe
Posted On: 15 Hours Ago
Replies: 5,447
Views: 935,776
0 Align intake manifold
Last Post: SHAKY DAVE
Posted On: 17 Hours Ago
Replies: 2
Views: 213
0 BEST LONG CHROME fILTER FOR 2001 EVO sPORTSTER
Last Post: Toejam503
Posted On: 22 Hours Ago
Replies: 10
Views: 547
0 oil filterchoices
Last Post: Toejam503
Posted On: 22 Hours Ago
Replies: 28
Views: 1,784
0 6 month old battery discharged and now won't charge at all
Last Post: Toejam503
Posted On: 22 Hours Ago
Replies: 9
Views: 344
0 "The Blues" thread!
Last Post: Stairman
Posted On: 23 Hours Ago
Replies: 1,152
Views: 178,223
More...
Members Birthdays
dtw757 (68), XLH75Rider (67), JRLang13 (60), Shaerona (58), christophe (55), collectovince (54), buckethead (44), Hang_Em_High (42)
Reply
 
Share Thread Tools Display Modes
  #161  
Old 14th February 2022
JimVonBaden's Avatar
JimVonBaden JimVonBaden is offline
Cool Aid!
 
Join Date: Nov 2021
Posts: 126
Sportster/Buell Model: 1200C
Sportster/Buell Year: 2004
Other Motorcycle Model: BMW R1200GS
Other Motorcycle Year: 2015
Reputation: 340923
JimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond repute
Default

Quote:
Originally Posted by ChinCactus View Post
I'd suggest replacing the o rings between the manifold and heads also as long as you are in there.
Yup, part of the plan.
__________________
Jim

2004 1200C

www.JVBProductions.com
Reply With Quote
  #162  
Old 14th February 2022
JunkyardDog JunkyardDog is online now
XL FORUM TEAM MEMBER
 
Join Date: Jul 2017
Location: Chandler, AZ
Posts: 120
Sportster/Buell Model: 1200 Low
Sportster/Buell Year: 2006
Other Motorcycle Model: Kawasaki Vulcan 750
Other Motorcycle Year: 2002
Reputation: 270884
JunkyardDog has a reputation beyond reputeJunkyardDog has a reputation beyond reputeJunkyardDog has a reputation beyond reputeJunkyardDog has a reputation beyond reputeJunkyardDog has a reputation beyond reputeJunkyardDog has a reputation beyond reputeJunkyardDog has a reputation beyond reputeJunkyardDog has a reputation beyond reputeJunkyardDog has a reputation beyond reputeJunkyardDog has a reputation beyond reputeJunkyardDog has a reputation beyond repute
Default

Yeah, that carb was dirty. I have the habit of removing and cleaning the carb on every used bike I get. Once done, I never have any more problems. I have a Japanese bike with 119K miles that I bought new, the carbs were off once, for rejetting, they did not need cleaning, and have never caused any issues. My Sportster was running a little lean, most likely because of the aftermarket exhaust it had when I got it. I rebuilt the carb with a CVP kit, which included larger jets, a different needle, and a thumbscrew to replace the pilot screw (the one that comes with the cap over it) so it could be adjusted while running.


In the third picture from the top I noticed the rubber elbow for the tank vent is badly deteriorated and cracked. And since it is, I would check out all the other rubber parts. Rubber parts near a Harley engine get really hot. I did replace the fuel hose and carb to manifold seal on mine, even though I didn't find any leaks. I've never had the manifold off. I use an unlit propane torch to check for vacuum leaks. Just open the valve a little and hold the nozzle around a place where you suspect there might be a leak. If there is, the engine will suck in the propane and the idle speed will go way up.
__________________
"You can't please everyone, so you got to please yourself" Rickey Nelson

"Buy the ticket, Take the ride" Hunter S Thompson
Reply With Quote
  #163  
Old 19th February 2022
JimVonBaden's Avatar
JimVonBaden JimVonBaden is offline
Cool Aid!
 
Join Date: Nov 2021
Posts: 126
Sportster/Buell Model: 1200C
Sportster/Buell Year: 2004
Other Motorcycle Model: BMW R1200GS
Other Motorcycle Year: 2015
Reputation: 340923
JimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond repute
Default

Thanks, will do!
Reply With Quote
  #164  
Old 19th February 2022
JimVonBaden's Avatar
JimVonBaden JimVonBaden is offline
Cool Aid!
 
Join Date: Nov 2021
Posts: 126
Sportster/Buell Model: 1200C
Sportster/Buell Year: 2004
Other Motorcycle Model: BMW R1200GS
Other Motorcycle Year: 2015
Reputation: 340923
JimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond repute
Default

On my first longish test ride I had an issue. At about 25 miles at 75mph it lost power and started kicking and bucking and some afterfire.



After some investigation I found that the intake boot was leaking. So I took it apart and rebuilt the carb.














All back together awaiting a check ride.

Reply With Quote
  #165  
Old 20th February 2022
sportsterpaul's Avatar
sportsterpaul sportsterpaul is online now
XL FORUM LIFE MEMBER
 
Join Date: Jan 2009
Location: In a swamp/Michigan
Posts: 16,379
Sportster/Buell Model: XL1460C
Sportster/Buell Year: 2000
Sportster/Buell Model #2: XL1200R
Sportster/Buell Year #2: 2006
Other Motorcycle Model: XL1200R
Other Motorcycle Year: 2004
Reputation: 16105848
sportsterpaul has a reputation beyond reputesportsterpaul has a reputation beyond reputesportsterpaul has a reputation beyond reputesportsterpaul has a reputation beyond reputesportsterpaul has a reputation beyond reputesportsterpaul has a reputation beyond reputesportsterpaul has a reputation beyond reputesportsterpaul has a reputation beyond reputesportsterpaul has a reputation beyond reputesportsterpaul has a reputation beyond reputesportsterpaul has a reputation beyond repute
Default

She looks anxious to get out, better give her some reign?
__________________
Pleasing everyone is impossible but pissing everybody off is a piece of cake!

The XL Forum Sportsterpedia:
http://sportsterpedia.com/doku.php/start
Reply With Quote
  #166  
Old 10th March 2022
JimVonBaden's Avatar
JimVonBaden JimVonBaden is offline
Cool Aid!
 
Join Date: Nov 2021
Posts: 126
Sportster/Buell Model: 1200C
Sportster/Buell Year: 2004
Other Motorcycle Model: BMW R1200GS
Other Motorcycle Year: 2015
Reputation: 340923
JimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond reputeJimVonBaden has a reputation beyond repute
Default

Got around to the front brakes today. I have previously bled them, but the pads were nearly gone, and the disc grooved. I replaced the pads and sanded the discs. I'll give it a ride this weekend.


Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT +1. The time now is 23:37.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2022, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC