The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 What Petcock
Last Post: Sadsack
Posted On: 1 Minute Ago
Replies: 15
Views: 2,085
0 Hottie of the day, no nudity.
Last Post: Stairman
Posted On: 4 Minutes Ago
Replies: 11,805
Views: 1,066,352
0 7 Dead and more wounded
Last Post: Graywolf
Posted On: 6 Minutes Ago
Replies: 26
Views: 968
0 Share your Sunrise OR Sunset Photos!
Last Post: Stairman
Posted On: 8 Minutes Ago
Replies: 12
Views: 267
0 45740-62 & 62A differences?
Last Post: Fridge
Posted On: 14 Minutes Ago
Replies: 17
Views: 3,048
0 Crusty's Travels
Last Post: Stairman
Posted On: 17 Minutes Ago
Replies: 2,232
Views: 276,656
0 Riding in The Heat!
Last Post: Sprtstr1200s
Posted On: 28 Minutes Ago
Replies: 12
Views: 435
0 Kickstarter return spring
Last Post: GA_Ironhead
Posted On: 39 Minutes Ago
Replies: 3
Views: 152
0 Axle mount license plate bracket question
Last Post: WVDevil
Posted On: 43 Minutes Ago
Replies: 14
Views: 77
0 Preston Candover, 23rd June 2019
Last Post: Folkie
Posted On: 50 Minutes Ago
Replies: 3
Views: 94
0 Efi and carbs
Last Post: boomerguy
Posted On: 55 Minutes Ago
Replies: 27
Views: 371
0 WTB - 48 take-off mufflers
Last Post: kent_kurt
Posted On: 1 Hour Ago
Replies: 4
Views: 116
0 ABS wheel locking?
Last Post: bustert
Posted On: 1 Hour Ago
Replies: 7
Views: 159
0 Tail and turns wiring
Last Post: sportsterpaul
Posted On: 1 Hour Ago
Replies: 11
Views: 200
0 Broke my drive belt (Stay With The Belt Or Do A Chain Conversion?)
Last Post: sportsterpaul
Posted On: 1 Hour Ago
Replies: 67
Views: 19,463
0 Rear axle - what am I doing wrong?
Last Post: bustert
Posted On: 1 Hour Ago
Replies: 4
Views: 79
0 2019 East Coast Meet and Greet
Last Post: mikeLI_77
Posted On: 1 Hour Ago
Replies: 349
Views: 36,439
0 Newbie from Tennessee
Last Post: sportsterpaul
Posted On: 2 Hours Ago
Replies: 8
Views: 122
0 Let's See Them R's!!
Last Post: Toejam503
Posted On: 2 Hours Ago
Replies: 1,532
Views: 566,506
0 Progress
Last Post: mickey t
Posted On: 2 Hours Ago
Replies: 19
Views: 440
0 Parrothead and the 2019 Iron Butt Rally
Last Post: sportsterpaul
Posted On: 2 Hours Ago
Replies: 63
Views: 2,746
0 **DK CUSTOM -*NEW* High-N-Tight License Plate Relo-Sportster & Dyna**
Last Post: DK Custom
Posted On: 2 Hours Ago
Replies: 5
Views: 1,453
0 DK Coil and Coil/Key Relocation Customer Review and Pics
Last Post: DK Custom
Posted On: 2 Hours Ago
Replies: 80
Views: 20,647
0 ***DK Custom - Stealth Adjustable Highway Peg Mounting Kit***
Last Post: DK Custom
Posted On: 2 Hours Ago
Replies: 3
Views: 571
0 Official XL Forum Random Image Thread (NO NUDITY!)
Last Post: Stairman
Posted On: 3 Hours Ago
Replies: 44,118
Views: 6,909,549
0 What did you do for your sporty Today?
Last Post: Bone
Posted On: 3 Hours Ago
Replies: 6,052
Views: 765,603
0 Roads I'd like to ride.
Last Post: Stairman
Posted On: 3 Hours Ago
Replies: 1,898
Views: 159,270
0 ***DK CUSTOM-4 New LIMITED QUANTITY Pegs-10% SAVINGS ON ALL PEGS***
Last Post: DK Custom
Posted On: 4 Hours Ago
Replies: 5
Views: 196
0 Iree's late night cafe
Last Post: Graywolf
Posted On: 6 Hours Ago
Replies: 1,247
Views: 153,270
3 Wtb, Wts, Wtt, Wtg (Ironhead)
Last Post: IronMick
Posted On: 6 Hours Ago
Replies: 120
Views: 230,039
More...
Members Birthdays
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,962
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 3656817
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,962
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 3656817
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,755
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1387912
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)



Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch, Energy One 15% heavier spring, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from 2012 street glide w/ matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

Dyno Sheet
96.21 HP/88.70 TQ


States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,962
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 3656817
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 19:37.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC