The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 Starts in gear
Last Post: IXL2Relax
Posted On: 6 Minutes Ago
Replies: 4
Views: 59
0 Rattling sound in Primary '92 1200
Last Post: Toejam503
Posted On: 11 Minutes Ago
Replies: 6
Views: 115
0 Greeting from CNY
Last Post: Toejam503
Posted On: 15 Minutes Ago
Replies: 9
Views: 121
0 Engine not running right.
Last Post: Toejam503
Posted On: 24 Minutes Ago
Replies: 7
Views: 112
0 900 heads contd..
Last Post: simonster123
Posted On: 29 Minutes Ago
Replies: 30
Views: 1,655
0 96’ 1200 rear axle torque spec
Last Post: T_worth
Posted On: 36 Minutes Ago
Replies: 0
Views: 14
0 Weld on hardtail
Last Post: Irishpowers
Posted On: 40 Minutes Ago
Replies: 13
Views: 192
0 Anyone make a DIY vibrating tumbler?
Last Post: sportsterpaul
Posted On: 46 Minutes Ago
Replies: 11
Views: 271
0 where did you put your xlforum patch?
Last Post: Toejam503
Posted On: 46 Minutes Ago
Replies: 13
Views: 266
0 Battery draining problem when running, but generator and regulator work?
Last Post: IXL2Relax
Posted On: 46 Minutes Ago
Replies: 3
Views: 54
0 Willi is back!!!!
Last Post: sportsterpaul
Posted On: 47 Minutes Ago
Replies: 12
Views: 3,191
0 Hottie of the day, no nudity.
Last Post: trainman
Posted On: 50 Minutes Ago
Replies: 6,574
Views: 467,720
0 Ethanol free gas...
Last Post: sportsterpaul
Posted On: 57 Minutes Ago
Replies: 63
Views: 9,536
0 2018 East Coast Meet & Greet
Last Post: sportsterpaul
Posted On: 1 Hour Ago
Replies: 385
Views: 21,959
0 Turn signal failure
Last Post: slamtry
Posted On: 1 Hour Ago
Replies: 31
Views: 970
0 Clutch removal tools
Last Post: Coolhands
Posted On: 1 Hour Ago
Replies: 4
Views: 176
0 Official XL Forum Random Image Thread (NO NUDITY!)
Last Post: trainman
Posted On: 1 Hour Ago
Replies: 40,525
Views: 6,217,552
0 Where do you ride in the lane?
Last Post: The Crusher
Posted On: 1 Hour Ago
Replies: 50
Views: 2,565
0 Show your favorite pic of your bike. just one
Last Post: trainman
Posted On: 1 Hour Ago
Replies: 4,680
Views: 1,721,280
3 Ironhead Pictures Thread
Last Post: what?
Posted On: 2 Hours Ago
Replies: 1,929
Views: 747,674
0 Iree's late night cafe
Last Post: Graywolf
Posted On: 2 Hours Ago
Replies: 890
Views: 79,401
0 Opinion on Chrome
Last Post: rejeanprimeau
Posted On: 2 Hours Ago
Replies: 13
Views: 544
0 The country store
Last Post: Stairman
Posted On: 2 Hours Ago
Replies: 233
Views: 10,498
0 Mikuni carb assembly questions. EricFreeman?
Last Post: Hexadecimus
Posted On: 2 Hours Ago
Replies: 0
Views: 32
0 Welding the sprocket to the drum? Can that work OK?
Last Post: bustert
Posted On: 3 Hours Ago
Replies: 4
Views: 163
0 Ignition problem?
Last Post: bustert
Posted On: 3 Hours Ago
Replies: 12
Views: 281
0 The forum got talent
Last Post: Hippysmack
Posted On: 3 Hours Ago
Replies: 28
Views: 1,283
0 This week on Craig's list
Last Post: screndname
Posted On: 3 Hours Ago
Replies: 3,539
Views: 337,023
0 My take on the world ~ Photo by Trace
Last Post: Nibelungen
Posted On: 4 Hours Ago
Replies: 730
Views: 72,951
0 2018 Custom 1200 (Red Light Came On)
Last Post: Tucsonmax1
Posted On: 4 Hours Ago
Replies: 2
Views: 71
More...
Members Birthdays
richard rees (69), IRONHD1K (65), derekb (57), Hankrebel (42), CPurner (37), Vickers
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,256
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2569457
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,256
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2569457
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,547
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1046623
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)



Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch with Energy One 15% heavier spring plate, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from a 2012 street glide with matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,256
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2569457
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 02:57.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC