The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 Were your parents anti bike?
Last Post: Glamazon
Posted On: 8 Minutes Ago
Replies: 22
Views: 269
0 Hi from the UK
Last Post: oreocat1
Posted On: 9 Minutes Ago
Replies: 5
Views: 20
0 Question of the month?!
Last Post: Nibelungen
Posted On: 13 Minutes Ago
Replies: 1
Views: 2
0 Ironhead primary filling with oil not puking
Last Post: The Doctor71
Posted On: 21 Minutes Ago
Replies: 5
Views: 145
0 Magnaflow F-Bomb on a Rigid?
Last Post: bustert
Posted On: 1 Hour Ago
Replies: 4
Views: 209
0 Official XL Forum Random Image Thread (NO NUDITY!)
Last Post: Graywolf
Posted On: 1 Hour Ago
Replies: 41,833
Views: 6,451,172
0 Keith Black Conversion
Last Post: hexnut
Posted On: 2 Hours Ago
Replies: 46
Views: 2,805
0 This is gonna hurt.
Last Post: Stairman
Posted On: 3 Hours Ago
Replies: 7,531
Views: 1,401,976
0 Hot Rods, Rat Rods, and Customs.
Last Post: Stairman
Posted On: 3 Hours Ago
Replies: 2,731
Views: 245,451
0 Roads I'd like to ride.
Last Post: Stairman
Posted On: 3 Hours Ago
Replies: 576
Views: 30,928
0 Will a 2000 swingarm bolt up/ fit my 99?
Last Post: jordan1200
Posted On: 3 Hours Ago
Replies: 18
Views: 313
0 Hottie of the day, no nudity.
Last Post: Stairman
Posted On: 3 Hours Ago
Replies: 8,421
Views: 676,417
0 nine T racer
Last Post: Nibelungen
Posted On: 3 Hours Ago
Replies: 6
Views: 169
0 :( New deep rebuild on my 90 inch
Last Post: conv90
Posted On: 4 Hours Ago
Replies: 124
Views: 10,481
0 Cylinder wall scoring after rebuild, can you live with it?
Last Post: Mad Max
Posted On: 5 Hours Ago
Replies: 4
Views: 215
0 Big bore stroker - the beginning of a 10-year long build
Last Post: RKN
Posted On: 6 Hours Ago
Replies: 800
Views: 72,647
5 Hots For An Xl Forum Member?
Last Post: Stairman
Posted On: 7 Hours Ago
Replies: 10,954
Views: 3,158,224
0 Good 2 into 2 exhaust?
Last Post: FearTheBeard
Posted On: 9 Hours Ago
Replies: 7
Views: 233
0 Does Synthetic Engine Oil cause Higher or Lower temps at the oil tank?
Last Post: Sportycus
Posted On: 10 Hours Ago
Replies: 91
Views: 16,990
5 Eye Protection When Riding?
Last Post: Graywolf
Posted On: 10 Hours Ago
Replies: 261
Views: 60,974
0 Gravydog crashed again.
Last Post: BKB
Posted On: 10 Hours Ago
Replies: 87
Views: 3,711
0 What color are your pipes?
Last Post: cazz1000
Posted On: 11 Hours Ago
Replies: 3
Views: 114
0 Relocated Turn Signals
Last Post: 1Scooter
Posted On: 11 Hours Ago
Replies: 2
Views: 67
3 Shaky Dave Recovery
Last Post: SHAKY DAVE
Posted On: 12 Hours Ago
Replies: 26
Views: 973
0 With this fit my 99
Last Post: jordan1200
Posted On: 12 Hours Ago
Replies: 11
Views: 239
0 1200s mid throttle stumble
Last Post: NZstu
Posted On: 13 Hours Ago
Replies: 18
Views: 334
0 KT - 2018 - Hop-along Highway
Last Post: IXL2Relax
Posted On: 13 Hours Ago
Replies: 38
Views: 3,649
12 Lets see the "C's" XLC's that is. Pics Please!
Last Post: Kejobe
Posted On: 13 Hours Ago
Replies: 1,183
Views: 421,605
0 Crusty's Travels
Last Post: Screw Loose Dan
Posted On: 13 Hours Ago
Replies: 1,651
Views: 171,913
3 Transmission Assembly, Tutorial w/Pics
Last Post: Rodzilla
Posted On: 13 Hours Ago
Replies: 73
Views: 50,550
More...
Members Birthdays
black pearl (74), SDREDD (57), pig (55), BonRu (53), cbass (45), ssm7530 (43), HawkeyeTX, SxysCowboy (35)
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,544
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2679679
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,544
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2679679
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,627
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1154533
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)



Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch with Energy One 15% heavier spring plate, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from a 2012 street glide with matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,544
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2679679
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 14:39.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC