The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 Automotive Motor Oil In Sportster
Last Post: NLXL
Posted On: 1 Minute Ago
Replies: 46
Views: 1,510
0 XR 750 steering head bearings
Last Post: mofosheee
Posted On: 3 Minutes Ago
Replies: 0
Views: 1
0 Q cams in 73 xlh ??
Last Post: 73HEAD
Posted On: 15 Minutes Ago
Replies: 51
Views: 2,298
0 "S" model specific Q&A
Last Post: Edster
Posted On: 30 Minutes Ago
Replies: 2,107
Views: 464,174
0 Keep & Kill
Last Post: hammer6315
Posted On: 35 Minutes Ago
Replies: 24,664
Views: 1,453,498
5 How do I increase sag ?
Last Post: Tomcatt
Posted On: 1 Hour Ago
Replies: 71
Views: 3,453
0 Official XL Forum Random Image Thread (NO NUDITY!)
Last Post: Iron Mike
Posted On: 1 Hour Ago
Replies: 52,012
Views: 8,752,659
0 What song do you have stuck in your head?
Last Post: hammer6315
Posted On: 1 Hour Ago
Replies: 2,416
Views: 257,416
0 HSR idle mixture screw
Last Post: bustert
Posted On: 2 Hours Ago
Replies: 5
Views: 153
0 It's Glamazon's Birthday!
Last Post: Crusty
Posted On: 2 Hours Ago
Replies: 2
Views: 24
0 Finally some nice weather in the northeast!
Last Post: Crusty
Posted On: 2 Hours Ago
Replies: 56
Views: 6,411
0 Hottie of the day, no nudity.
Last Post: Stairman
Posted On: 5 Hours Ago
Replies: 32,145
Views: 3,737,367
0 What gas mileage do you get for touring?
Last Post: SonWon
Posted On: 7 Hours Ago
Replies: 156
Views: 62,696
0 Track Bike Build
Last Post: shanneba
Posted On: 7 Hours Ago
Replies: 3
Views: 158
0 Stroker pistons
Last Post: Steve9
Posted On: 13 Hours Ago
Replies: 99
Views: 5,671
0 Pushrod hitting tube
Last Post: DR DICK
Posted On: 14 Hours Ago
Replies: 21
Views: 1,168
0 need help with 68 XLH
Last Post: DR DICK
Posted On: 16 Hours Ago
Replies: 17
Views: 1,066
0 1983 Roadster
Last Post: RicThompson
Posted On: 17 Hours Ago
Replies: 21
Views: 754
0 Range With EFI 3.3 Gal Tank
Last Post: Mike1nw
Posted On: 19 Hours Ago
Replies: 97
Views: 73,077
0 who has NOT had problems with the XL
Last Post: handa700
Posted On: 21 Hours Ago
Replies: 770
Views: 220,273
0 Gear and brake linkage
Last Post: Andy56
Posted On: 21 Hours Ago
Replies: 8
Views: 164
0 Oil pressure switch
Last Post: sportsterpaul
Posted On: 23 Hours Ago
Replies: 5
Views: 248
0 This week on Craig's list
Last Post: Steve9
Posted On: 23 Hours Ago
Replies: 5,370
Views: 881,294
0 Iree's late night cafe
Last Post: Steve9
Posted On: 23 Hours Ago
Replies: 2,132
Views: 358,928
0 Valve Stem Seal ID
Last Post: BruceM
Posted On: 23 Hours Ago
Replies: 6
Views: 194
0 Anyone go racing last weekend?
Last Post: Tinz
Posted On: 1 Day Ago
Replies: 3,402
Views: 384,929
0 What oil temp do you run
Last Post: John Harper
Posted On: 1 Day Ago
Replies: 134
Views: 31,746
0 Food porn
Last Post: Stairman
Posted On: 1 Day Ago
Replies: 2,497
Views: 578,351
0 Clutch Spring plate poll
Last Post: Bluto
Posted On: 1 Day Ago
Replies: 313
Views: 78,482
0 why you can't be seen
Last Post: Les59
Posted On: 1 Day Ago
Replies: 31
Views: 10,402
More...
Members Birthdays
jdhickm (86), Chip (73), Chief4x4 (71), willyobiker (69), CBryant (68), XLCH69 (65), sage (62), Butch (62), VettesRule (59), jerseyjeff (59), TheExecutioner (56), SalTheWop (56), manic_mechanic, pauldmedic16 (47), BluegrassXL (43), Superman
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 22,361
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4957844
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch (now with Barnett Pressure plate and 25% stiffer spring)
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 22,361
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4957844
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,972
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1723729
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)


Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch, Energy One 15% heavier spring, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from 2012 street glide w/ matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

Dyno Sheet
96.21 HP/88.70 TQ


States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 22,361
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 4957844
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT +1. The time now is 17:25.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC