Rigid_EVO Cylinders and static compression checked. Advise?

[jordan1200]

Ok I did a static compression test last night and got 170 psi per cylinder (engine cold).
Seems a bit low doesn't it. Before the teardown and piston replacement I had about 180 psi.
I have about 1200 km. on the top end. I did a check at about 800 km and I got 180 psi.. (cold engine).
Now I took my telescopic camera into the combustion chamber and the front cylinder looks pretty clean still. The rear has me concerned. See pictures

Front cylinder first picture


Sent from my SM-G930W8 using Tapatalk

[bustert]

well if you just replace parts, it might take awhile to seat in. so a ?
did you do a bore? or just a hone?
did you check for taper?

[jordan1200]

Originally Posted by bustert

well if you just replace parts, it might take awhile to seat in. so a ?
did you do a bore? or just a hone?
did you check for taper?

Bored 0.010" over with factory Buell pistons

Sent from my SM-G930W8 using Tapatalk

[jordan1200]

Any thoughts on the pictures?

Sent from my SM-G930W8 using Tapatalk

[bustert]

had to say over the net
but
hd cyl's do not run the same, look at how they are fueled
i run diff heat ranges to even out the two plug wise