The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > FORUM FUNCTIONS > Introduce Yourself
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

Introduce Yourself Tell us about yourself and your bike

Active Threads
0 What did you do for your sporty Today?
Last Post: clif02
Posted On: 3 Minutes Ago
Replies: 5,454
Views: 623,930
0 Recommendations for a good parts vendor
Last Post: Martysf
Posted On: 7 Minutes Ago
Replies: 14
Views: 563
0 Does Synthetic Engine Oil cause Higher or Lower temps at the oil tank?
Last Post: John Harper
Posted On: 15 Minutes Ago
Replies: 90
Views: 16,495
0 1986 1100 butterfly carb on going problems
Last Post: Flam
Posted On: 36 Minutes Ago
Replies: 0
Views: 1
5 Favourite grips?
Last Post: Stairman
Posted On: 39 Minutes Ago
Replies: 50
Views: 9,092
0 Patriot Defender whats the next best exhaust?
Last Post: Bryan1976
Posted On: 49 Minutes Ago
Replies: 153
Views: 26,400
0 What Sort Of Sporty Have You Got?
Last Post: Lone Rider
Posted On: 1 Hour Ago
Replies: 1,047
Views: 274,422
0 Paughco Tank 866XL1 – 2.9 Gallon Capacity
Last Post: heyshott 81
Posted On: 1 Hour Ago
Replies: 3
Views: 138
0 Dealer says, "Sportsters are just a Phase"
Last Post: lostNdallas
Posted On: 2 Hours Ago
Replies: 427
Views: 29,785
0 Air cleaner backing plate screw size?
Last Post: Folkie
Posted On: 2 Hours Ago
Replies: 3
Views: 39
0 Why I am leaving the forum!
Last Post: khav
Posted On: 3 Hours Ago
Replies: 93
Views: 15,781
0 Crusty's Travels
Last Post: ChinCactus
Posted On: 3 Hours Ago
Replies: 1,645
Views: 171,489
0 1200s mid throttle stumble
Last Post: NZstu
Posted On: 3 Hours Ago
Replies: 8
Views: 157
0 Hottie of the day, no nudity.
Last Post: trainman
Posted On: 3 Hours Ago
Replies: 8,372
Views: 671,589
0 Topend problem
Last Post: brucstoudt
Posted On: 4 Hours Ago
Replies: 28
Views: 627
0 Screw Loose's Repairs
Last Post: Screw Loose Dan
Posted On: 4 Hours Ago
Replies: 310
Views: 47,120
0 Lets see your off season builds
Last Post: cycowrencher
Posted On: 4 Hours Ago
Replies: 1,133
Views: 122,081
0 New England 2018
Last Post: mick42
Posted On: 4 Hours Ago
Replies: 222
Views: 11,293
0 Food porn
Last Post: Graywolf
Posted On: 5 Hours Ago
Replies: 880
Views: 118,218
0 09 Buell XB12 crank
Last Post: aswracing
Posted On: 6 Hours Ago
Replies: 2
Views: 53
0 What are your thoughts on this 2004 rubbermount Sporty?
Last Post: Nibelungen
Posted On: 6 Hours Ago
Replies: 67
Views: 2,810
0 Occasionally pops out of 2nd
Last Post: ericfreeman
Posted On: 6 Hours Ago
Replies: 5
Views: 279
0 What engine oil do you use?
Last Post: SLW210
Posted On: 7 Hours Ago
Replies: 443
Views: 85,016
0 Hot Chicks on Hot Bikes
Last Post: Stairman
Posted On: 7 Hours Ago
Replies: 9,276
Views: 1,417,881
0 This week on Craig's list
Last Post: frogg_nutts
Posted On: 7 Hours Ago
Replies: 3,613
Views: 368,136
0 Small nail in tire?? plug or replace
Last Post: jammantoo
Posted On: 8 Hours Ago
Replies: 134
Views: 19,574
0 Suzuki Lights On 883
Last Post: robbie202
Posted On: 8 Hours Ago
Replies: 72
Views: 1,867
0 Anyone try the new Conti tour tires
Last Post: robbie202
Posted On: 9 Hours Ago
Replies: 5
Views: 180
0 Happy Birthday Hogwylde!!!!
Last Post: Edster
Posted On: 9 Hours Ago
Replies: 3
Views: 69
0 You asked for it! "The Tess' Coffee Thread"
Last Post: rokytnji
Posted On: 9 Hours Ago
Replies: 10,332
Views: 715,468
More...
Members Birthdays
irvingjr (70), 909XR (61), Ghost_FL (59), mark R (58), TWISTED (45), spade (43), Drivethis29 (38), dodgetrucken (33)
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #11  
Old 1 Week Ago
Scuba10jdl's Avatar
Scuba10jdl Scuba10jdl is offline
XL FORUM TEAM MEMBER
 
Join Date: Dec 2010
Location: Columbus, Ohio
Posts: 1,276
Sportster/Buell Model: XLH883/1250
Sportster/Buell Year: 2002
Sportster/Buell Model #2: XLCH 1000
Sportster/Buell Year #2: 1972
Reputation: 292656
Scuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond reputeScuba10jdl has a reputation beyond repute
Default

Welcome my friend! Starting an ironhead, especially a kick only CH, can be a challenge if you've never done it before. Here's the sequence I use for mine ( carb S&S Super E with acclerator pump):

- Ignition off
- Full choke
- Twist throttle once (accelerator pump squirts)
- Kick through one cylinder
- Twist throttle again
- Kick through second cylinder
- Bring crank to compression and ready to kick
- Ignition on
- Kick like hell

At this point it should start right up. If it pops out the carb, it's lean and you didn't prime it enough or you kicked too slow. If it backfires, your timing is probably off.

If it doesn't start the first try and didn't pop out the carb or backfire (a little hiccup is okay), then kick it again.

If it fails to start on the second kick, turn off the ignition, close choke, open the throttle all the way and kick through three or four times. Then start back at the top.


The first time I tried to start mine I had my buddies out there watching me, we were all drinking some beers, and it was hot as hell Ohio summer. I spent about 45 minutes kicking and kicking, and doing everything every which way. After much ridicule, and my buddies getting shamed failing to start it as well, we put it away and I came back to it the next day. Read a similar procedure to above and tried that. Over time I've perfected it for my bike. Each one is different, so don't think you have to do it exactly how I do as it may not even work for your bike that way! (But it should get you pretty close.)
__________________

2002 XLH883/HAMMER1250 - 1972 XLCH 1000 - Few things in life are as satisfying as riding a Sportster with no destination in mind.
Reply With Quote
  #12  
Old 3 Days Ago
hoggy's Avatar
hoggy hoggy is offline
XL FORUM TEAM MEMBER
 
Join Date: Aug 2009
Posts: 318
Sportster/Buell Model: xl 1200
Sportster/Buell Year: 1994
Reputation: 3665
hoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the roughhoggy is a jewel in the rough
Default

welcome & enjoy.
Reply With Quote
  #13  
Old 3 Days Ago
juzyHD's Avatar
juzyHD juzyHD is offline
Senior Chief Know It All 2nd Class
 
Join Date: Mar 2015
Location: Europe Slovenia
Posts: 1,470
Sportster/Buell Model: sportster 1200
Sportster/Buell Year: 1986
Reputation: 268144
juzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond reputejuzyHD has a reputation beyond repute
Default

Welcome from Slovenia!
Reply With Quote
  #14  
Old 2 Days Ago
echale3 echale3 is offline
XL FORUM TEAM MEMBER
 
Join Date: Sep 2018
Posts: 10
Sportster/Buell Model: XLCH
Sportster/Buell Year: 1971
Reputation: 10
echale3 is an unknown quantity at this point
Default Well....

The carb is a Bendix, not the Tillotson, and when I got it, the bike wasn't running. Turns out the rear pushrods were WAY out of whack to where the intake/exhaust in the rear weren't even opening and closing, the points were gapped wrong, the static timing was unable to be set because of wear on part of the points that rides on the timing cam, and the carb had a leak. Took care of all of that, and put in a fresh battery, and it still won't go, so I'm going to tweak the carb settings a bit and see if that helps.


I'll be quizzing the Ironhead forum guys shortly, and thanks for all the advice and welcomes!
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 02:38.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC