The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 XLH 883 1987. Please advise. (Jetting And Air Filter)
Last Post: xlh883-1987
Posted On: 3 Minutes Ago
Replies: 7
Views: 27
0 vibration problem solved - CHECK YOUR FRONT ENGINE MOUNT BOLT!!
Last Post: Bruce
Posted On: 11 Minutes Ago
Replies: 325
Views: 191,397
0 My 1250 to 1275 build
Last Post: Bruce
Posted On: 13 Minutes Ago
Replies: 62
Views: 2,430
0 Locked up rear wheel
Last Post: Darkseacret
Posted On: 31 Minutes Ago
Replies: 47
Views: 2,015
0 25 April
Last Post: Glamazon
Posted On: 32 Minutes Ago
Replies: 9
Views: 131
0 Happy Birthday Decman!!!
Last Post: decman
Posted On: 38 Minutes Ago
Replies: 10
Views: 115
0 This week on Craig's list
Last Post: sltm1
Posted On: 56 Minutes Ago
Replies: 3,989
Views: 452,844
0 Trans sprocket spacer is stuck
Last Post: xleddie
Posted On: 56 Minutes Ago
Replies: 0
Views: 1
6 Calling all musicians
Last Post: Hippysmack
Posted On: 1 Hour Ago
Replies: 404
Views: 17,782
0 Been Sitting For 5-10 years; Starts, But Dies
Last Post: Feskerlars
Posted On: 1 Hour Ago
Replies: 5
Views: 128
0 1986-90 Evo Sportsters: What every owner should know but were afraid to ask
Last Post: Hippysmack
Posted On: 1 Hour Ago
Replies: 317
Views: 36,797
3 Wtb, Wts, Wtt, Wtg (Ironhead)
Last Post: borada75xlch
Posted On: 1 Hour Ago
Replies: 154
Views: 225,085
7 Saying hello and getting acquainted!
Last Post: Flyboy25
Posted On: 1 Hour Ago
Replies: 19
Views: 334
0 My '08 short chop
Last Post: Dudepants
Posted On: 1 Hour Ago
Replies: 168
Views: 23,872
0 Official XL Forum Random Image Thread (NO NUDITY!)
Last Post: Graywolf
Posted On: 2 Hours Ago
Replies: 43,546
Views: 6,802,255
0 2004 rear mast cylinder
Last Post: rocketmangb
Posted On: 2 Hours Ago
Replies: 1
Views: 20
0 Hot Chicks on Hot Bikes
Last Post: Stairman
Posted On: 2 Hours Ago
Replies: 9,850
Views: 1,612,048
0 left him stranded
Last Post: davixlrtt
Posted On: 2 Hours Ago
Replies: 4
Views: 133
0 THE Hockey Thread
Last Post: Airbozo
Posted On: 3 Hours Ago
Replies: 4,019
Views: 266,282
6 73 Sportster Starts, Runs Fine, Dies
Last Post: davixlrtt
Posted On: 3 Hours Ago
Replies: 15
Views: 400
0 How many have converted their 883 to 1200?
Last Post: Huginn
Posted On: 3 Hours Ago
Replies: 386
Views: 103,110
0 Evo sporty straw diagonal measurement... 883? 1200?
Last Post: ericfx1984
Posted On: 3 Hours Ago
Replies: 3
Views: 110
0 Gasket goo or not to goo
Last Post: Jollly Rogers
Posted On: 4 Hours Ago
Replies: 5
Views: 111
0 Rear rocker cover?
Last Post: doodah man
Posted On: 4 Hours Ago
Replies: 24
Views: 1,228
0 Resistor vs Copper plug wires?
Last Post: GA_Ironhead
Posted On: 4 Hours Ago
Replies: 26
Views: 613
0 77 xlh front end front vibration
Last Post: rokytnji
Posted On: 4 Hours Ago
Replies: 7
Views: 334
0 Crusty's Travels
Last Post: SonWon
Posted On: 4 Hours Ago
Replies: 2,118
Views: 257,149
0 Scored new to me used tins
Last Post: Toejam503
Posted On: 5 Hours Ago
Replies: 2
Views: 71
0 BETTER Brakes for $214
Last Post: NLXL
Posted On: 5 Hours Ago
Replies: 20
Views: 3,294
0 First Startup after rebuild questions
Last Post: frogg_nutts
Posted On: 5 Hours Ago
Replies: 13
Views: 455
More...
Members Birthdays
Durockrolly (61), xlch1973 (57), Rich_Alfredo (57), ehenry (55), 100thHugger (54), evobrian (52), jethrosurfs (47), Chris B. (43), Ebmomma (43)
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,838
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 3605256
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,838
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 3605256
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,722
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1387912
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)



Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch, Energy One 15% heavier spring, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from 2012 street glide w/ matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

Dyno Sheet
96.21 HP/88.70 TQ


States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,838
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 3605256
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 21:53.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC