The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Notices

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 Official XL Forum Random Image Thread (NO NUDITY!)
Last Post: Graywolf
Posted On: 5 Minutes Ago
Replies: 41,215
Views: 6,319,670
0 71 front end question
Last Post: ogmudbone85
Posted On: 8 Minutes Ago
Replies: 3
Views: 71
0 Food porn
Last Post: Graywolf
Posted On: 10 Minutes Ago
Replies: 771
Views: 90,733
0 Lots of issues 78
Last Post: ezmerf
Posted On: 21 Minutes Ago
Replies: 1
Views: 11
6 Asgardia Regional area
Last Post: DEEP DIVER
Posted On: 24 Minutes Ago
Replies: 10
Views: 315
0 New to the Harley Brand
Last Post: GeoK
Posted On: 37 Minutes Ago
Replies: 9
Views: 84
0 Big bore stroker - the beginning of a 10-year long build
Last Post: RKN
Posted On: 43 Minutes Ago
Replies: 732
Views: 64,632
0 Spark Plugs
Last Post: ezmerf
Posted On: 43 Minutes Ago
Replies: 13
Views: 610
0 Ironhead Rendez-vous - Event for Ironhead owners of Ontario
Last Post: scottfisher
Posted On: 44 Minutes Ago
Replies: 8
Views: 337
0 Roads I'd like to ride.
Last Post: Stairman
Posted On: 51 Minutes Ago
Replies: 295
Views: 11,796
0 O2 Sensor, p/n 27719-07, is it 12mm or 18mm ? - 2011 XL1200CP
Last Post: The Doctor71
Posted On: 52 Minutes Ago
Replies: 3
Views: 143
0 Help With Oil Flow
Last Post: Ferrous Head
Posted On: 54 Minutes Ago
Replies: 15
Views: 539
0 78 new Ultima ignition problems
Last Post: Mrhorn12
Posted On: 1 Hour Ago
Replies: 0
Views: 14
0 What coil(s) do you run with your Dyna S ignition?
Last Post: needspeed
Posted On: 1 Hour Ago
Replies: 6
Views: 119
0 Sportsterpedia Progress
Last Post: Hippysmack
Posted On: 1 Hour Ago
Replies: 163
Views: 32,415
0 What's your helmet?
Last Post: Nibelungen
Posted On: 1 Hour Ago
Replies: 44
Views: 2,400
0 Starter circuit without relay
Last Post: ChicagoSlim
Posted On: 1 Hour Ago
Replies: 2
Views: 35
0 runs-on after kill button pressed
Last Post: 72 Ironhead XLH
Posted On: 1 Hour Ago
Replies: 15
Views: 455
0 1981 XLH turns over won’t start
Last Post: BlackAce
Posted On: 1 Hour Ago
Replies: 4
Views: 38
0 Taillight Problems '96 Sporty
Last Post: night-train
Posted On: 1 Hour Ago
Replies: 6
Views: 262
0 oil pump breather screen
Last Post: Gold Member
Posted On: 2 Hours Ago
Replies: 15
Views: 364
0 Sizing cylinders too pistons
Last Post: randy3934
Posted On: 2 Hours Ago
Replies: 10
Views: 362
0 Scorpion Clutch / Mueller Easy Pull
Last Post: Four Speed
Posted On: 2 Hours Ago
Replies: 14
Views: 198
0 Gotta Start a Thread for the Streetfighter Too!
Last Post: tigger
Posted On: 2 Hours Ago
Replies: 65
Views: 2,942
0 Exhaust Wrap Questions
Last Post: bustert
Posted On: 3 Hours Ago
Replies: 15
Views: 275
0 Handlebars: stock Iron/48 vs Chumps
Last Post: priell3
Posted On: 3 Hours Ago
Replies: 5
Views: 635
0 Yetman drag frame
Last Post: Slojoe55
Posted On: 3 Hours Ago
Replies: 27
Views: 11,046
0 1998 Sportster Ignition Problems
Last Post: james69
Posted On: 3 Hours Ago
Replies: 20
Views: 616
0 Hottie of the day, no nudity.
Last Post: Stairman
Posted On: 4 Hours Ago
Replies: 7,593
Views: 558,548
0 Shovester Sighting
Last Post: bill smith
Posted On: 4 Hours Ago
Replies: 65
Views: 7,163
More...
Members Birthdays
epconde (61), floydfan222 (58), Brian (53), Rondall (53), Nightster Man, Scarecrow2311 (49), thatbikerguy (49), SprtyGirl (47), freecdp45 (47), rxr, addy76 (42), sportster883r (38), Steeljester (37), 98xl1200s (32)
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,419
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2679679
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,419
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2679679
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,590
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1076922
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)



Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch with Energy One 15% heavier spring plate, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from a 2012 street glide with matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 20,419
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 2679679
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 22:21.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC