The Sportster and Buell Motorcycle Forum - The XLFORUM®
 

Go Back   The Sportster and Buell Motorcycle Forum - The XLFORUM® > SPORTSTER MOTORCYCLE & BUELL MOTORCYCLE FORUM - GENERAL DISCUSSION > Organize a Group Buy
XLF Blogs XLF Arcade XLF Disclaimer/Privacy Statement/Terms Of Use

Organize a Group Buy Here is where you can organize a group buy. Anyone can organize a group buy to include commerical vendors. This is only section that non-supporting vendors may mention their products but only in conjunctions with a group buy.

Active Threads
0 What did you do for your sporty Today?
Last Post: Highly-Dangerous
Posted On: 29 Minutes Ago
Replies: 6,469
Views: 846,640
0 Crusty's Travels
Last Post: Davo_137
Posted On: 1 Hour Ago
Replies: 2,604
Views: 344,855
0 05 883xl question re: jet size
Last Post: Highly-Dangerous
Posted On: 1 Hour Ago
Replies: 6
Views: 94
0 Speed
Last Post: Highly-Dangerous
Posted On: 1 Hour Ago
Replies: 6
Views: 85
0 never mind
Last Post: Highly-Dangerous
Posted On: 1 Hour Ago
Replies: 4
Views: 184
0 1200 conversion
Last Post: Highly-Dangerous
Posted On: 1 Hour Ago
Replies: 11
Views: 329
0 Not an ironhead, but....
Last Post: brianbbs67
Posted On: 2 Hours Ago
Replies: 5
Views: 159
0 latest project sorrry not an ironhead.
Last Post: brianbbs67
Posted On: 2 Hours Ago
Replies: 3
Views: 57
0 Anyone hunting an XLCH in a Norton Featherbed Project?
Last Post: Peteroo
Posted On: 3 Hours Ago
Replies: 42
Views: 2,214
0 xr1200 thottlebody on xb heads (does it fit?!)
Last Post: t120r
Posted On: 3 Hours Ago
Replies: 2
Views: 65
0 98 Stator Removal / Inspection / Installation
Last Post: sportsterdoc
Posted On: 3 Hours Ago
Replies: 42
Views: 1,138
0 Analog to digital speedometer install...
Last Post: Tinz
Posted On: 3 Hours Ago
Replies: 3
Views: 136
0 Keep & Kill
Last Post: Graywolf
Posted On: 4 Hours Ago
Replies: 14,359
Views: 806,004
0 On starting a new thread
Last Post: Ferrous Head
Posted On: 4 Hours Ago
Replies: 3
Views: 114
0 Cometic Valve Stem Seal Install?
Last Post: BlackBikeDave
Posted On: 5 Hours Ago
Replies: 14
Views: 307
0 This week on Craig's list
Last Post: Maxeffort
Posted On: 5 Hours Ago
Replies: 4,468
Views: 546,132
0 Will 04 and later used jugs & pistons fit 01 without major problems?
Last Post: tussuck
Posted On: 5 Hours Ago
Replies: 10
Views: 283
0 What's your opinion on windshields?
Last Post: Glamazon
Posted On: 5 Hours Ago
Replies: 1,203
Views: 205,043
0 To Lace or Not to Lace, or While We're Doing This...
Last Post: Tim The Grim
Posted On: 5 Hours Ago
Replies: 12
Views: 334
0 Daily updates by email not working
Last Post: billeuze
Posted On: 5 Hours Ago
Replies: 5
Views: 159
0 2007 Sportster xl883l (low) 3k original miles
Last Post: Skeezix
Posted On: 5 Hours Ago
Replies: 23
Views: 537
0 5 gal tank
Last Post: sportsterpaul
Posted On: 6 Hours Ago
Replies: 56
Views: 17,664
0 Pictorial Essay, my town, Waterloo, Ontario
Last Post: sportsterpaul
Posted On: 6 Hours Ago
Replies: 14
Views: 4,133
0 How much is a late 60's early 70's Sportster worth?
Last Post: Magneto Sportster
Posted On: 6 Hours Ago
Replies: 21
Views: 1,303
0 opinion time (bike broke again)
Last Post: Skeezix
Posted On: 6 Hours Ago
Replies: 9
Views: 376
0 What Kind of Gas Treatment Do You Use?
Last Post: NLXL
Posted On: 6 Hours Ago
Replies: 19
Views: 570
0 testing wiring harness connections
Last Post: sportsterdoc
Posted On: 7 Hours Ago
Replies: 9
Views: 151
0 2011 1200C tuner?
Last Post: tussuck
Posted On: 7 Hours Ago
Replies: 5
Views: 289
0 Timing
Last Post: ryder rick
Posted On: 7 Hours Ago
Replies: 14
Views: 441
0 Seeking advice on shorter rear shocks
Last Post: ezmerf
Posted On: 7 Hours Ago
Replies: 21
Views: 661
More...
Members Birthdays
xlhrick (74), madrat (68), gripdad (65), ask4dug (63), TinMan_4L (58), jrhayden (57), norseXL (54), ftcara (53), rick600, thebisch (49), wademclean, smooth8423 (44), timmaboy (43), mxmike800 (29), OddOneOut (28)
Sponsored Links
Reply
 
Share Thread Tools Display Modes
  #1  
Old 9th March 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,217
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 3885606
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default Air Filter Elements for Hammer or NRHS housings

OK gang !
I'm going to order a special build air filter for the OVAL shaped 3" high filter from K&N
This is a true oval on both sides as opposed to being a Tri Oval on one side like supplied with the housings.
I understand its a matter cost so it uses an off the shelf unit.
The custom filter would run about $100.00 shipped more than 10 would run about $80.00 shipped
The standard replacement HD2076 runs $50.00 depends on vendor.

Any interest send me a PM
__________________
Thy Sportster Come
It Shall Be Done
On Earth as it is on Salt
2006 Sportster XL1250C
Hammer Sledge Heads 1.98X1.61 Valves
Hammer 600 Cams
Big Ass CP/Hammer Pistons
Mikuni HSR 45 /Hammer Billet Manifold (Now HSR 48)
Jetted 27.5 slow,182.5 Main
97 Needle,Clip posistion 3
Hurricane Flow 3" offset AC,Rocketman Mod
Daytona Twin Tec TC88A,Rico Scarecrow Map
Sumax Thundervolt plug wires,NGK DCPR8EIX spark plugs. Gapped .040 and Indexed
Cycle Electric Stator and Regulator
Alto Carbonite Clutch (now with Barnett Pressure plate and 25% stiffer spring)
Royal Purple 20W50 MC Primary oil
Patriot Defender Pipe
Royal Purple 20W50 MC Engine Oil
Napa 7148 oil filter
Max Power, 111.47
Max Torque, 84.39
Best 1/4 Mile ET to date 11.85
Best 1/4 Speed to date 115.14
Build by Jester Motorwerkz West
Reply With Quote
  #2  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,217
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 3885606
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Bump it up bump !
Reply With Quote
  #3  
Old 2nd April 2018
mikeLI_77's Avatar
mikeLI_77 mikeLI_77 is offline
XL FORUM LIFE MEMBER
 
Join Date: Nov 2004
Location: Long Island, NY
Posts: 4,815
Sportster/Buell Model: XL1250c
Sportster/Buell Year: 2002
Reputation: 1427232
mikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond reputemikeLI_77 has a reputation beyond repute
Default

What is the benefit to this?
__________________
2002 XL1200C (originally)



Hammer 1250 kit W/ 30° reverse dome pistons, billet 2.25" crush forward offset open air cleaner, billet intake manifold, Impact 560's, Sledge Hammer pushrods, Buell XB heads with crush level head porting, Mikuni HSR 45, 177.5 main, 25 slow, Clip 4th slot from top, Jim's powerglide II lifters,
Supertrapp supermeg exhaust 20 disks and open end cap, S&S roller rockers, Alto Carbonite clutch, Energy One 15% heavier spring, Daytona twin tech single fire ignition 1005s
Ricor intimnators, 13" Ricor IAS shocks, Brembo dual disk setup from 2012 street glide w/ matching brembo street glide master cylinder,
Koso T&T multi function speedo/tach

Dyno Sheet
96.21 HP/88.70 TQ


States I Have rode through
Reply With Quote
  #4  
Old 2nd April 2018
rocketmangb's Avatar
rocketmangb rocketmangb is offline
XL FORUM TEAM MEMBER
 
Join Date: Jan 2008
Location: So Cal
Posts: 21,217
Sportster/Buell Model: XL1200C
Sportster/Buell Year: 2006
Sportster/Buell Model #2: XL1200C
Sportster/Buell Year #2: 2006
Other Motorcycle Model: 48 "Totalled" By a Douche
Other Motorcycle Year: 2012
Reputation: 3885606
rocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond reputerocketmangb has a reputation beyond repute
Default

Mike
This fits the housing better in my opinion
It uses the same mold on both sides unlike the HD 2076 filter you have now
Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Sponsored Links
All times are GMT +1. The time now is 09:07.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
XL Forum® - Linson Media LLC