- Sporty Hiccup!
- 76 Ironhead....
- Need some help on relocating the ignition and coil
- Swapping handlebars and speedo wiring
- tach problems
- Running Lights
- What the hell do I do with it?
- BASE GASKET LEAK
- Am I in trouble?
- head porting question
- Internal Wiring in Bars
- fuel &oil line sizes for 89 -883h ???
- oil pump screen...easy to clean?
- need help running lines to cooler/filter
- Cheap relay checker
- Red Shift 567 cams >
- Won't start....clicking noise
- how much HP do i have???
- qUICK HELP WITH THE SE PROGRAMMABLE IGN MODES
- Fixed it! --> "Help, my new bike only runs on 1 cylinder"
- Cam install help needed
- RE-wire suggestions
- Once ... twice ... three times a rocker cover oil leak
- Relocation of the Coil!!
- Stevo and guys I need a manual for the buell/ evo screamin eagle ign part #32942-02
- Soldering??
- Plug wires
- speedo problem
- oil cooler?
- '05 883 hiccups (need help)
- Do I need to prime the oil pump?
- Rev Limiter
- New Owner / Won't Start
- Normal oil temp??
- bow tie wrench ?
- Just Plain FUNNY
- RALPHIE..THE GUAGES...
- Passing lamp set
- just put on my aurora taillights.
- installing a new round key ignition to my 89 XLH hugger
- Auxiliary Switch Housing
- need help wiring some dummy lights
- AUXILLARY STOP AND TAIL SISSY BAR LAMP
- Famous Rocker Cover leak - how hard to fix?
- ...'04R running bad after oil change, need help
- Here is a tricky one....
- Will not start (SOMETIMES)
- Question on Auxillary lights
- Timing..do I have it right?
- Battery removal
- Electrical Problem
- What do I need for 80/80
- Help..wiring problem, not solved by service manual...1988 sporty
- New passing lights
- Completed wiring, Going to have to get used to new buttons.
- Ignition module?
- Time For Plan B With Springer Horn
- need help with math on sunpro tach
- Rocker box spacers
- need help with timing
- tom metty
- GOD what a PITA the SE ignition password re-learn is!!!!!!!!!!!!
- 500 mile oil change??
- 30MPH What gear!!!
- speedometer sensor removal
- Magnecor wires for 04 Sporty..Where to buy???
- Euro folks with '05 headlights?
- A/F Ratio ???
- rpm question
- Speedo-Tach combo???
- Help me clear something up.
- Oil Tank
- XB and .497 SE's
- Installed a Tach on my '04 1200 Custom!
- Speaking of heat.............
- MSD ignitions-Anyone tried?
- thunderbolt heads?
- Burning up headlight connector
- '04,'05 Ignition upgrades
- Probably a silly question but........
- Tacho reads double what it should
- Enrichener Problem
- To cam, or not to cam
- Left turn lights not working!
- SYN3 Oil Gain Horsepower?
- Hard starting when hot.
- How to remove and install timer cover
- Moving front turn signals
- compression test
- Ghost in the Charging system?
- I read a schematic!!!
- Anti theft light
- Roller Lifters
- 04 Tachometer wire harness
- test tach
- Crane lifters and an install question >
- Very little oil getting the motor's top end >
- Holding down the jugs when the heads are removed?
- Got a Vibe in the engine what is it?
- Oil Level
- LED Lights, Headlight Modulator & Electrical
- Oil Type...HD oil/amsoil?
- first ride...paraniod questions
- ok i'm lost now have loud rattle can't figure out
- Take a look at my damaged SE .551 cams >
- Another "Oil" Thread
- signal light out and half tail light working
- single fire coil
- synthetic oil study
- Anyone ever heard of these guys? - Johnson Engine Technology
- CLEANING OIL RESIDUE FROM UNDERSIDE OF MOTOR?
- cold engine - rich mixture
- HD conspiracy rocker gaskets, they suck balls
- Zippers Red Shift 567 cams and RB Racing LSR 2-1 exhaust > NEW
- Hmmm, no spark what-so-ever.
- spark plugs and wires
- Moving lights for hard bags
- Missing Oil
- Dumbass deed of the day
- Oil Leak - Rocker Cover
- Removing filter without spilling oil
- miss at cruise and decel
- brighter headlight
- Noise from lifters.
- Looking for quality 'dyno' oil > Diesel oil too thin
- Andrews N3s
- VOES adjustment
- Tailight Problems
- headlight ,junction boxes
- Installing New Lights
- Loctite Blue & Electrical Contacts
- Anyone use these turn signals before?
- Tail light wireing modification question > Help
- SE dual plug Heads
- Possible case gasket leak?
- Wiring air kill switch
- Oil Leak... Rocker Area
- Identify this taillight
- Spark Plugs: measurement/adjustment
- ez- tach(inductive)?
- SE ignition module / Start problems
- Running alittle warm...
- 96 up controls
- Startor Relay to startor
- enrichner quest.
- Rocker cover oil leak for the fourth time; need advice
- off topic but need to know
- Metal washers on U shaped breather leaking oil
- Cam bushings / line reaming
- Kurykyan LED Taillight
- Just finished upgrading my run-turn-stop rear lighting system
- break light switch, adjustable?
- Somebody Help!!!
- Valve Noise On 1999 1200XL
- backfiring when cold ..
- Fat Bob Tank? Have You Done This?
- Replacing Rocker Gaskets
- Battery Problems
- Banging my head against my Sporty. . . .
- Fried my turn signal/brake light kit with LED
- No Tail Light or Brake Light!
- ALCOHOL AS A STREET FUEL???
- using buellS fairing on 1200 C
- need help with a small electrical problem
- 87 1100-1200 machinegunning
- speedometer question
- Hemi Design
- Educate me on spark plugs
- Rear lights are gone
- wiring up custom turnsignals
- Oil Cooler Advice
- Mixing different types of oil
- Complete engine teardown on a 2005 883C
- Cam install screw up..sort of
- Quick oil leak fix
- Front Turn Signal Replacement
- Your oil change tips and tricks
- Bike had an oil bath
- Engine backfired and quit
- oil leak near motor mount
- 1984 tail light problem
- Question: Rev-Tech roller rocker arm install
- Running trouble...can't get to the bottom of it
- 2 in 1 speedo tach ????
- Dowel Pin Question
- light problems
- Buell engine in 1992 Sportster
- 883 burning oil
- 2000 Ignition Module Wiring Diagram
- whacked tach
- Installing 04-05 Ajustable Pushrods How-To >
- 73 Starter Spinning out, not engaging
- "B" Reflash done...OUTSTANDING!
- SE coil????
- optimate battery charger
- Engine Doesnt Start
- Is tach needed?
- probably a stupid question
- Cam recommendation for '05 1200R
- $800 to work with
- Daytona twin tec ignition module
- How do I use Scotch Lock Connectors?
- Oil temp
- brake light
- Daytona Twin Tech or Spyke or etc?
- building a 200hp sporty motor
- Oil question
- Spark-less
- Consīderīng an Oīl Cooler
- Installation of SE cams voided my 2 year warranty
- I think it might be time to put up the wrenches.
- starter question
- HELP!! Lost Spark
- TURN SIGNAL MODULE
- Blowing Fuse???
- Faulty alternator or battery?
- Saw this bike w/a brilliant blue light by license plate...
- Oil puking from breather
- Varying oil level problem.
- 1980 XLH 1000 Directionals not working properly
- Time For An Oil Change?
- Next Move
- Customer Satisfaction at NRHS >
- some tech questions.
- Hypercharger
- Thinking about what to do to my 883 engine...
- Advice requested
- Daytona Twin Tech Ignition
- Ahhh fancy schmancy Hi-4 ignition :)
- Noise after SE Ignition Install
- motor mount bolt in head.
- Ye GODS there's a hole in my piston!
- What is this piece?
- Getting worried
- Tips and tricks , PLEASE!!!
- OIL LEAK
- HEEELP! Need advice ASAP...wrenching on bike right now...
- Zippers Performance?
- Synthetic or conventional?
- replace stator screws?
- A service lesson learned
- Converting points to EI
- cam question kinda technical
- stator problem
- Head comparison 04 and 05
- Did Harley make evo bathtub sporty heads
- Overheating on hot days
- I think my speedo is off
- Porting and polishing heads
- Ride ended in smoke, need help..