View Full Version : Ironhead Sportster Motorcycle Talk (1957-1985)
- Ironhead Oil Pressure Light Issues
- Ironhead how fast should my 79 go?
- Ironhead new motor sprocket nut issue
- Ironhead mad scientist project
- Ironhead No oil to top or crankcase.
- Ironhead I'm on the road!....1st ride out.......speed wobble at 90MPH!!!
- Ironhead Where can I get a new steering stem?
- Ironhead Forward Controls on 84...
- Ironhead speedo (not the kind ya wear)
- Ironhead brakes dragging..
- Ironhead stripped engine mount bolt hole/shavings into tranny
- Ironhead Another exhaust question (with a twist)
- Ironhead Performance upgrades?
- Ironhead ok so just to verify tha ti am correct
- Ironhead Do i Have an oiling issue?
- Ironhead The Beast Has Awakened
- Ironhead Intermitent smoke and a some clutch advice needed
- Ironhead 73 starting ??
- Ironhead Shifter very hard going down
- Ironhead Primary plugs (Tool help)
- Ironhead I tore into The Tranny that locked up
- Ironhead what about shift forks
- Ironhead Almost got her on the road!!
- Ironhead Oil pump retro fit?
- Ironhead Andrews R5 cams
- Ironhead Front cylinder leaking compression... (pictures)
- Ironhead '84 Ironhead Motor Mounts and a Flyrite Frame...
- Ironhead What would cause..
- Ironhead Engine noise??
- Ironhead rebuilt carb is on
- Ironhead Bike wouldn't start
- Ironhead charging
- Ironhead Everytime I take my bike out something falls off!
- Ironhead First Harley First build
- Ironhead Super E Jetting
- Ironhead newer sporty front end on ironhead?
- Ironhead Front Brakes 77' Sportster Chopper
- Ironhead Spits and Cuts out at high RPM
- Ironhead 79 sportster-run,off switch
- Ironhead What's my Ironhead worth?
- Ironhead thanks guys/gals this vid's for you
- Ironhead In need (Enthusiast Magazine)
- Ironhead poor throttle response
- Ironhead Pushrod tube fun
- Ironhead looking for 60's era fork lowers
- Ironhead is an electronic speedo possible
- Ironhead engine hangs when shifting
- Ironhead Irons, snakes and stockings
- Ironhead just wondering if these fenders etc will fit
- Ironhead Stainless braided brake hose - I like it.
- Ironhead Getting ready to ride again ...
- Ironhead 1st attempt at making my own bars
- Ironhead seats for a 76 xlh1000
- Ironhead Primary Cover Screws
- Ironhead Shredded tappet and guide - Need advice
- Ironhead Left Brake Didnt Get Me....Close Call.
- Ironhead timing oil pump need help
- Ironhead Newer shocks on an older style ironhead frame?
- Ironhead what year is this frame
- Ironhead intermittent Idle
- Ironhead suggestions for a new carb.
- Ironhead More advance woes
- Ironhead IronHead Forum Member Videos
- Ironhead lowering forks on a 75 XLH
- Ironhead How to Lift the rear end (get all weight off of the rear suspension)
- Ironhead 4 speed to 5 speed
- Ironhead Sealing up a pin-sized hole in a gas tank
- Ironhead Kickstarter jammed?
- Ironhead Where can you get the ACCEL advance weight assbly?
- Ironhead Switchable Years/parts??
- Ironhead 72 sportster...Question
- Ironhead Clutch cable prob.. HELP
- Ironhead Oil pukage (vent issue)
- Ironhead Help with bearings/bushings
- voltage regulator wiring
- Ironhead how many clutch discs?
- Ironhead cam cover
- Ironhead gas line run question
- Ironhead search sucks...any ideas?
- Ironhead Known problems to look for before buying -81 or -85?
- Ironhead govener?
- Ironhead Sparkplug
- Ironhead 2 inch drag pipes with baffles
- Ironhead having issues understsanding what size rear fenders fit
- Ironhead '70 new clutchpack, not enough adjustment
- Ironhead How long for parts from J & P?
- Ironhead trouble shifting with boots
- Ironhead 1976 front end rebuild problem?
- Ironhead '77 Ironhead or '99 BMW??
- Ironhead engine issues
- Ironhead no compression when hot
- Ironhead shift lever questions
- Ironhead Self threading nuts.... How to keep them tight?
- Ironhead wtf where did my oil all go need help
- Ironhead 1980 wiring issues
- Ironhead 72 Oil Tank Question
- Ironhead determining bore size of cylinders
- Ironhead is this the oil vent?
- Ironhead '60XLH - the official "revival attempt" thread
- Ironhead PB+ Cams
- Ironhead Ignition- which one?
- Ironhead 1960 XLH Tank Paint Job
- Ironhead just saying "hi"
- midrange rpm miss
- Ironhead Quick plug/ign. and oil question. 70 xlch
- Ironhead Making my bike "mine"
- Ironhead What Wheel?
- Ironhead clunk clunk at idle
- Ironhead need to wire up the 65
- Ironhead newer carb older bike
- Ironhead Cylinder to Piston Clearances
- Ironhead Question for anyone with an 80 hardtail
- Ironhead '70 XLH vs XLCH chain guard size
- Ironhead FOUND AN IRONHEAD! Need advice!
- Ironhead Clutch Ring Install
- Ironhead Spontaneous combustion (clutch)
- Ironhead Ignition cover
- Ironhead stripped bleeder
- Ironhead Cheap seat looks like a million bucks!
- Ironhead Gear changes (clunky transmission)
- Ironhead Idleing problems
- Ironhead Little old ladies
- Ironhead Crane HI-4 Ignition on '77 XLH
- Ironhead Had So Much Fun With The Fire Bike Im Doing Anouther
- not getting any juice to the spark plugs
- Ironhead Just got my 76 iron started
- Ironhead New pics of the '66! WARNING lots of pics!
- Ironhead New advance springs are REALLY light
- Ironhead S&S Carb filter
- Ironhead loss of power
- Ironhead fr and rear sprockets????
- Ironhead Tranny Oil Change tool
- Ironhead Sprocket/chain changing
- Ironhead Tach is off by a lot....... what are revs at 60MPH?
- Ironhead 1975 Swingarm
- Ironhead Pilot Jet Size????
- Ironhead Rear Master Cylinder Sucking Fluid?
- Ironhead Primary oil blowing out
- Push rod disassembly
- Ironhead Accel advance unit
- Ironhead Sorted the Ig. timing
- Ironhead vin id question, and yes, I have read all the vin web pages
- Ironhead Is there a good advance unit made anymore
- Ironhead About to shank someone with a blunt object... please advise
- Ironhead 1979 Sportster XLH 1000 rear chain guard
- Ironhead Throttle help
- Ironhead New bike in the garage
- Ironhead mother bleeping bleep bleep
- Ironhead Spoke to soon
- Ironhead Exhaust cross-over & carb tuning
- Ironhead tire to chain clearance
- Ironhead 1969 XLCH up and running
- Ironhead rebuild trans 1965 900 need help
- Ironhead Indentifying top and second ring
- Ironhead Starting issue
- Ironhead Someone need a project?
- Ironhead Clearance of steering stem and upper tree
- Ironhead Rear fender advice wanted.
- Ironhead Sick Ironheaed, please checkout video
- Ironhead Unbelievable
- Ironhead Retiming Gearcase Breather valve, Am I on the right track.
- Ironhead tranny oil
- Ironhead air out the timing plug?
- Ironhead Electrical Issues
- Ironhead Tires
- Ironhead 77 rebuild- head sandblast/finish question
- Ironhead Regulator issue?
- Ironhead Some Nice Riding Today (pics)
- Ironhead 82 xlh wont start
- Ironhead Generator Noise vs Drive Gear Size, Part 2
- Ironhead Goon News, Bad News, and Questions
- Ironhead OIl tank exhaust clearence
- Ironhead 84-90 alternator problem
- Ironhead 1994 Windshield on a 1973
- Ironhead compensator sprocket?
- Ironhead Wheel Bearings & Rear Brake Spring
- Ironhead copper head gaskets
- Ironhead spark plugs for 77 1000
- Ironhead shifting 1982 trans
- Xl Bearing Numbers
- Ironhead Worn flywheel crank pin hole
- Ironhead cutting out?
- Ironhead FooFoo again
- Ironhead fuses? where do i need em
- Ironhead Piston ring compression tool
- Ironhead oil Flow
- Ironhead Heres something neat for the shop wall
- Ironhead Front brake?
- Ironhead How much of a perfectionist are you/running rich?
- Ironhead This I would like to have....
- Ironhead Ironhead miss
- Ironhead will exhaust leak?
- Ironhead 1972 Ironhead Restoration..
- Ironhead I'm putting in new valve guides and need some info
- Ironhead Just got 1972 ironhead
- Ironhead Exhaust Pipes Smoking - BAD!
- Ironhead Almost ready.
- Ironhead 1969 XLCH Revival
- Ironhead Bosch voltage reg qestions
- Ironhead help with cam cover leak (pics)
- Ironhead 74 xlh
- Ironhead Advance Unit
- Ironhead billetwerx neck cups
- Ironhead My 69 Sportster
- Ironhead Another Great Ride in the PNW!
- Ironhead Forget Orange County Choppers
- Ironhead 1974 XLH basket
- Ironhead Cleaning up
- Ironhead What's up with this? (runs erratically, bogs down)
- Ironhead Electric Starter help
- Ironhead XLX Sportster
- Ironhead Countershaft 1st gear
- Ironhead electronic module
- Ironhead lost fire pls help
- Ironhead Needed a tranny main shaft for 71 to 83
- Ironhead Help me choose cams
- Ironhead Fork Tightening help
- Ironhead My 1969 XLCH
- Ironhead Jokeying around
- Ironhead Master cylinder advice
- Ironhead The two hole in master cylinder fluid chamber?
- Ironhead It is not suposed to be like this...
- Ironhead S&S throttle cables?
- Ironhead speedo options?
- Ironhead fork oil
- Ironhead Poor Man's XL Tips
- Ironhead Charging system issues
- Ironhead why would I keep blowing headlights
- Ironhead Fatbob and wideglide
- Ironhead Timing marks??
- Ironhead Weld on hardtail
- Ironhead It STARTED!!!!, Now what???
- Ironhead clutch issues
- Ironhead starting problems
- Ironhead Let the pipes go blue or not?
- '66 No Spark
- Ironhead S and S Jetting
- Ironhead ok not a harley but........
- Ironhead Primary Oil weight
- Ironhead So, Who Went Riding on the 4th? (pics)
- Ironhead 73 Sportster (Springer Help Please.)
- Ironhead Tappet Guide Leak
- Ironhead fork problems... No rebound or dampenng
- Ironhead My first trip with my new ride (OBS, LOTS of pics!)
- Ironhead continously adjusting clutch
- Ironhead Vibration
- Ironhead Generator putting out negative voltage
- Ironhead starter ?
- Ironhead bbq on the 4th
- Ironhead So how many of you are running without cam shims?
vBulletin® v3.8.5, Copyright ©2000-2013, Jelsoft Enterprises Ltd.