View Full Version : Ironhead Sportster Motorcycle Talk (1957-1985)
- runs like crap...
- I sold out.
- bike whont start
- Evo in ironhead frame?
- gen light, more problems
- does anyone have any c-4?
- Major Primary Problem!! Any Advice????
- Sourcing Aftermarket Parts
- Now that starter and solenoid are gone, where do I hook up the positive battery cable
- not about a sportster but...
- Motor mount gone?
- cam timing
- Got an Ironhead story?
- Anyone have a bolt-on hardtail?
- Did autolite plugs make your bike run bad??
- Slow Jet Size
- 80 Xlc Year question
- Getting close...
- Ironhead Cams
- update on my 77 build
- Hats Off To Nohander For The Free Peg Supports!
- Three prong plug on ignition module
- brake lines
- The Resurection begins
- Magneto Timing
- Well it seemed like a good idea
- Who's Comin' To Myrtle Beach This week?
- Crank Oil Seal
- tip on oil changes
- 83' rear brake locking up... need some advice.
- leaky tranny
- Carb Rebuild at Last.....
- Need feedback on single fire...
- New to HD
- 80 "restoration?" update
- Anyone put a rack on their bike?
- What wheels fit?
- upper Motor Mounts
- Round Air Cleaner Bolt Too Long
- Accelerator Pump and Fast Idle
- what do i look for in a valve?
- Fossil, Oregon
- generators over my head
- OLD vs NEW
- Update on ignition module replacement
- CV carb for Ironhead
- Carb Q
- Lowering Kit
- '77 starter acting up
- Wide White Wall Tire Question?
- King tanks and oil coolers
- Picking up $500 Sporty saturday
- Finally got my ironhead together.
- Searching for suicide shift for Ironhead Sportster 1983 XLX
- my 77 ironhead
- should I buy this 79 sportster ?
- Thanks Mike13 & Y2K
- 11.1/2 shocks
- HELP! Clutch problems.....
- Shooting flames
- Parts Used or Free
- key??
- My 80 Is Done!!!!
- Quick Oil Route Question
- Im confused and in need of help
- replaced valve, now it wont start
- Rocker Box Oil Pressure Gauge
- Got my $500 sporty pics
- converting forks on a 1974 xl
- The Quest for Knowledge Begins.
- New Copper Lines and Pressure Gauge
- rigid frame rear tire
- I got-R-done
- chain to belt?
- hi all i am new here and need help!
- Magneto Problems
- noise
- better introduce myself...
- I need help with a solo seat qestion
- oil pressure sending unit/pressure gauge
- Bike won't start
- early sportster gas tank decals?
- For my 30th bike........a Harley
- I've gone Ape!!!!!!!!!!!!!!
- '67 sporty
- Looking for parts that fit
- drum to hydraulic
- Update
- drain plug
- 1974 Sportster
- about time to quit.
- Primary question
- generator problem over
- Made New Break Light and Sissy Bar
- Strociek Sportster Stuff
- Exhaust question
- I come before yo once again for your insight and infinite wisdom
- Little engine paint does wonders
- Knocking under the cam cover.
- Oil
- ive had enough
- Sadly have to sell...
- $500 Sporty update w/pics
- Drive sprocket seal
- Crankcase drain plug stripped
- Installing Sprocket on rear drum
- Piston rod horizontal play
- Pic Request
- 77 drum to spocket/disc brake conversion
- What wheel fits?
- Check the picture...does anyone have these warning lights?
- better keep those old bikes .
- More trouble....
- Primary cover cap S.O.S.
- Charging System Test
- black smoke, oily plugs. how bad is it?
- Whos Got A S&s Super B.....
- shooting flames
- Back rest measurements
- oil line size
- wait a sec..is this right.
- Petcock for King Tank
- Rebuild Time!!!!
- Andrews cams,Lightened Idler, Mini Alternator, HATE the NOISE !!
- 1974 Sportster tranny
- Thanks to all, and more questions
- prestolite starter
- Broke down again
- 85 Ironhead
- She's Finally done!!!!
- Speedo/Tach bracket
- Possibly dumb regulator/generator problem...
- polarizing the generator
- 90 sporty case half
- i got another one!( you knew it wouldnt be long didnt you?)
- Cant Decide
- Ironhead Charging System Checkout
- Old Sportsters Getting Rare
- Swingarm Stretch
- noise in cam cases
- front wheel
- Carb fart @ 60mph???
- Need Tech Help Please
- so...where do you get yours?
- Speedo Drive? Can it be serviced???
- Antique plates for my 57?
- 74 xlch trannsmission fluid change?
- Carb question!
- first ride
- Rear motor mount cracked
- have to pull the motor
- bungee nuts, be careful
- horsepower ?
- Kicker conversion for a 82 XLH
- for ironmike
- leaky oil drain plug
- where is my speedo pick up on a 77
- Routing oil lines
- brass shifter bushing
- 84 shift lever
- Iron Head Racing
- Ironhead coming into the shop...
- Ironhead Single vs. dual fire ignition
- Fixed My Horn
- Home Made Bolt & Washer Baffles
- how do I get the jugs out?
- How Much Compression ?
- please tell me this is a bent valve!
- on of harleys better ideas.
- oil pump check ball?
- new clutch, hard ride, oohhh noooo slip
- Ironhead hardtail instructions ?
- New guy sayin Hi
- Dreaded Oil Question!
- What is the classic XLCH worth?
- The rare '79 Sportster being parted out...
- Break Shoe Springs
- Hey gang, new headlight dim as shit, any ideas
- Ironheads are tough!
- cv intake manifold
- Super E float level ?
- Jugs out
- 1979 XL Chopper for sale on Craigslist (Chicago)
- Bendix Carb Adjustment
- Paint?
- Fattest Rear Wheel?
- 3 old bikes
- 84 hard tail questions
- Almost finished
- Frame Diameter
- EVO sporty motor in IRONHEAD FRAME?
- pukin oil
- Detailing question?
- Difference between '72-E73 and later
- howdy all
- oil cooler install
- Rear Fender looks too high?
- '72 puking oil
- Floorboards on a '71 Sportster...?
- Stuck Horn
- "Downgrade" to Bendix carb
- Big twin front end: What cups/bearings?
- 79 Rear Fender Spacers
- I am happy
- '77 GEN light on at idle?
- Is there a part # for this? Check pic...
- Got the Bike Back
- spark plug fouling
- Ahh Brakes
- Looking for how and where to check tranny fluid
- Help with jetting and or carb adj.
- Shifting Question
- Picture request...
- I need to resolve some issues
- New bike, lots of work
- 84 and 85 clutch plates the same?
- Primary Chain Adjuster Broken!
- whats a good pillion seat?
- lower my 76
- 74 Sporty Chopper 4 sale, $3800.00
- shorty super E
- swap to elec ignition
- '72 Stroker dilemma
- Where could I find a single fire set up?
- Tach.
- Drive Chain- O ring VS conventional
- Gen light & Voltage Regulator
- Part#16684-71,16682-71
- Clutch slipping and need help
- year differences....
- Bendix Carb Issue
- HD grade 105?
- 85 ironhead clutch same as early evolution?
- Soooo Close
- kill switch
- brain buster
- Which Octaine for 71 Sportster...?
- Vapor Lock??
- How screwed am I?
- speedo question
- making a solid harley?
- Into
- turn signal hook up
- 85 clutch - Strange part?
- S&S E throttle cable?
- Exhaust on an ironhead with forwards
- Spark Plug Gap
- Popped my "Cherry"
- What color of paint?
- Help from all the "King" Tank Owners
vBulletin® v3.8.5, Copyright ©2000-2013, Jelsoft Enterprises Ltd.