View Full Version : Sealing a new tank
8th February 2011, 06:19
I haven't found any info yet on the best way to pressure test/seal an EFI tank. I bought one brand new in bare metal but I'm not sure how to plug the EFI mounting hole. small sheet of rubber with a flat piece of wood maybe? I dunno. looking for ideas.
8th February 2011, 06:27
I always used a cork cut to fit the holes in the tank. What are you going to use to seal the tank. Hopefully you don't have Kreem. Many people on here have had problems with Kreem. Both POR 15 and Red Kote work well. Make sure you follow the instructions closely. Most problems occur from taking short cuts. Good luck!
8th February 2011, 15:32
A cork won't fit the EFI hole.
I spent about 3 hours researching the innernetz last night and came to the conclusion that kreem is not the best way to go. It's going to be POR or Red Cote for me.
Thanks for the reply
vBulletin® v3.8.5, Copyright ©2000-2013, Jelsoft Enterprises Ltd.