View Full Version : Ironhead xr 1000 oil line route
17th April 2011, 20:49
greetings wondering if someone has a clear diagram of where the oil lines go on a xr1ooo theres a diagram in the manual but its not clear enough for me its on a custom setup so not worried so much about the passage they take just where they end up thanks for any info:clap
17th April 2011, 21:41
This might help.
18th April 2011, 03:29
Its in the manual, do you have one?
I will try to scan tomorrow if you dont have available.
18th April 2011, 05:28
hi i think the xr has a slightly different setup, anybody got a hand drawn diagram that shows eg oiltank to pump , pump to oil filter,oilfilter to ra ra ra. ill be putting in a remote oil filter in there somewhere else well. i have a brass fitting just below the rear pushrod cover thinkin this may be for the rear head drain back to the sump or a vent?? i have a manual but its a bit vague to me, not worried to much about the route of the lines as is a custom setup thanks for any info
18th April 2011, 05:35
If its what I see Page 3-12 in the manual its petty much there, maybe you have something different? Your filter should be after the motor on the tank return line.
18th April 2011, 10:10
Not sure if this one helps?
18th April 2011, 13:21
Post some pics of your tank, oil pump area, fittings, etc. Not too many [none?] XRs here but someone will be able to help.
20th April 2011, 01:06
I have an XR1000 & remember routing the oil lines was not fun. Depends on what mods you have done to the engine. send me your email & I can send some pictures & info Don't know how to attach pictures on this forum
20th April 2011, 01:38
... Don't know how to attach pictures on this forum ...
How To Post Photos
vBulletin® v3.8.5, Copyright ©2000-2013, Jelsoft Enterprises Ltd.