Ok, i've got my spedo working which was an easy job, but my tach is all wires along with all the back lights to both. I was looking at the wiring diagram and it seems that all i have to do to get the tach going is wire it to the coil where the Ignition module connects. Is that right?

Also, to get the lights working, i just wire both bulbs to a positive and ground? Is it really this easy?

If it isn't obvoius, i am not extremely experienced with electrical. I've done numberous car stereos and little gadjets here and there. But not a working reliable system. Any input will help.

-marshall

Ok, i've got my spedo working which was an easy job, but my tach is all wires along with all the back lights to both. I was looking at the wiring diagram and it seems that all i have to do to get the tach going is wire it to the coil where the Ignition module connects. Is that right?

Also, to get the lights working, i just wire both bulbs to a positive and ground? Is it really this easy?

If it isn't obvoius, i am not extremely experienced with electrical. I've done numberous car stereos and little gadjets here and there. But not a working reliable system. Any input will help.

-marshall

The tach only needs that signal wire to the coil. A ground and a 12V also.
As for the lights I can't help. Not sure what lights you're talking about.

Marshall,

yes it is that easy. sounds like you have a handle on it.

solder all your connections and use heat shrink to cover them.

make sure there is enough wire to allow smooth steering stop to stop.

good luck. let us know how it works out.

Hey thanks for the info guys. The lights I am rambling about are the one that light up the gauges so you can see em at night. I am going to dummy wire something up this weekend and see if i can't get a response. Thank you. :)

You got it,its that easy just did mine acouple days ago.