View Full Version : Engine flush
10th April 2006, 22:27
Just tore the heads and cylinders off for upgrade. The oil was quite black when I drained it out. Are there any recommended "engine flushing" compounds to rince out the bottom end prior to reassemble.
10th April 2006, 22:49
This is what I did during rebuild to clean out the crankcase. I bought a gallon of diesel oil and poured about a third or so of it into the crankcase. Then pumped it out using a MityVac. Repeated three times and made sure to pump all of it out.
10th April 2006, 22:57
depending on the year parts cleaner is pretty cheap for 5gal and is made for parts
10th April 2006, 23:10
What about that stuff they have for cars that you put in, run the engine for five minutes, then change the oil. Is that ok for the bike?
10th April 2006, 23:12
Diesel or kerosene,cheap and effective;)
11th April 2006, 03:48
18th May 2006, 21:20
I use kerosene too...
18th May 2006, 21:43
i would rather see you just change the oil at 500 miles a few times. one little flake of something in the engine can starve lubrcation to a oil galley and ruin the engine.
vBulletin® v3.8.5, Copyright ©2000-2013, Jelsoft Enterprises Ltd.