bought some aftermarket signals...

was swapping them out... one by one.. i checked each signal as it was installed... left and right and everything worked perfectly... (the new signals are just plug and play... no splicing involved..)

i got to the last one... which was the front right signal... (front left if you're standing in front of the bike looking at it..)
and once i unplugged it and plugged in the new signal.. all of them stopped working..

even if i plug the original stock signal back in...

they are not led's or anything like that.... the fuses are were fine... idk what else it could be..

is there like a "main wire" that connects all signals that maybe i disconnected??? could it be the flash relay???

it's an 02 buell blast.. only has 6600 miles on it....

Sorry to hear about your troubles. If the lights were on when you plugged it in (I mean electricity going to the connector) it may have shorted out the bulb. Also pull the fuse and look close. If ok, check each bulb. the flasher may have shorted it dosen`t take much. This is a dumb question but did you cycle the key. The breaker may have shut off also. Good luck.

Probably a bulb blew , and took the flasher unit with it - its happened to me - lol
EZ

I think your problem is main relais, over the main rfront line, probabily you cretaed a short circuit.