Hello, just joined and could really use some help. I'm building a custom chopper using the engine out of my 2002 Buell X1. I would very much like to run the fuel injection but am not sure how to do it at the same time running drag pipes. I'm assuming I would need a power commander, but does it work in place of or with the 'race only' ecm I have? And will the FI even work with drag pipes? I understand there may be a performance loss on the bottom end, but if i'm willing to accept that, can the PC3 be mapped to run with the drag pipes? Would a different FI computer be better? Could I make a baffle or use torque cones to make the proper backpressure needed?

My setup would be a forcewinder-stock 2002 X1 engine-wet dreamz drag pipes by pipedreamz.

Any and all help would be appreciated.

Thanks!