Looking for exhaust (something cool!!!)

[Crusin_w00kie]

http://www.frankieserranodesigns.com/frankie_serrano_designs_hotrods_buyform_a.php

I know these are for the BT's but they just look sooooo bad-ass. You guys know if anyone out there makes something like this for us Sporty owners???

[Roadster_Rider]

Damnit, all my bookmarks got deleted, theres a place that makes some with a similar shape to that, they're not chrome though, they come wrapped, they're pretty cheap too, they look badass, i'll try to do some digging if you're into wrapped pipes.

[Crusin_w00kie]

Thanks Roadster!! :)

[rharrison356]

Those are great looking pipes...post some pictures if you find some that will work on the EFI bikes.

[Quebeker]

You guys know if anyone out there makes something like this for us Sporty owners???


check with these guys (http://www.ragerbuiltchoppers.com/exhaust.htm)

[xllent01]

Check out Pipedreamz (http://www.pipedreamz.biz/pipez.html)there pipes rock.:banana


PM or e-mail supporting member Leo Frantic (http://www.xlforum.net/vbportal/forums/member.php?u=759)he carries them and sells to XLF members.

[Robohead]

Led Sled Customs has some pretty cool sporty exhausts. Not exactly like the pipes you mentioned, but still cool looking. Go here: http://www.ledsledcustoms.com/ and then click on "ShopOnline" and you will see a sporty exhaust section.

[coonass]

http://www.cycleholic.com/evoxl.html

[Gone]

http://www.frankieserranodesigns.com/frankie_serrano_designs_hotrods_buyform_a.php

I know these are for the BT's but they just look sooooo bad-ass. You guys know if anyone out there makes something like this for us Sporty owners???


Did you notice the very short length and note that a velocity stack is required? Good luck getting the bike to run well.

[Roadster_Rider]

I think he means something along the lines of the same shape and style, if they're smaller diameter they'll work better.

[Gone]

I saw a guy last summer who made his own - probably took less than an hour to build. A Honda CB350 twin and he had cut both primary tubes to about 18" - just before the lower bend. The tubes were mounted so they angled up towards the right hand grip. He went by me on the freeway at about 65 mph and I haven't heard such awful racket since I was in the Marines............ He must have gone permanently deaf five minutes after his first ride.

[Crusin_w00kie]

I think he means something along the lines of the same shape and style, if they're smaller diameter they'll work better.

Exactly!!!


I did find these at LedSled....pretty neat lookin IMO.
http://www.ledsledcustoms.com/pics/product/exhaust2.JPG
Qualifier Pipes
http://www.ledsledcustoms.com/products.asp?id=49&cat_section=

[sprtrjl]

I like the pipe dreamz pipes. Didn't know the Ledsled guys were makin pipes. May have to check them out. about 3 miles from my house.